30 Amp DPDT On-Off-On Rocker Switch

Replaced OEM 1983 rear AC blower switch as shown in pic. Fits in the dash panel cutout perfectly. To use, you will need to cut off the factory plug connector and use individual insulated disconnects on each wire (2, 12 AWG and 1, 16 AWG). Each row of switch terminals is separate they do not interconnect electrically - so just use one row (ie 1,2,3). Grey hot wire to center term 2, low (yellow) and high (Orange) wires can go to each side 1 and 3. The Grey wire is from Bat fused at 20 Amps in the panel, Orange is load to fan, yellow to resistor in evaporator case. High does not use resistor

I needed this to add Neutral to my grandson's Powerwheels KFX. I modified the 4 wheeler toy to have 18v motors, aluminum 1st gears, 6 sealed batteries, and an external charging port. I used this switch so that it could handle a bit higher current (the old 2 position switch melted) and to add neutral to the former selections limited to forward or reverse. It required a little "enlargement" to the cutout to fit - BUT it works great now!

The engine cover on my boat has a motor to lift it up. Came with a mom on off mom on. One side failed, so it would only go up. This is not a mom on off mom on, it's on off on. You have to turn back to off instead of just take your finger off. Works for me so I don't have to sit and hold the switch while to cover goes up or down. Just have to be there to turn it off when the lift gets to end of travel. Fit right in where the old one was. I'll update later to say how it's holding up.UPDATE Nov 2015: Still works, no issues.

Action is nice. I needed 12volt and up to 30A. Looks like it will work. 4 start because I only just got it.

Seems to be well made but it didn't work for my application so I can't comment on how it worked in use.

I ordered a heavy duty rocker switch for my trolling motor, the original got hot and quit working, contacts were carbonized and housing was melted. This switch is a good replacement.

Bilge pump switch on my boat internally broke and fell apart. This new switch snapped into the hole in the mounting plate and works fine.

This product received 4 stars because I found the toggle to be a bit stiff.Otherwise this is a perfect switch. The fit was almost perfect for my IS300