No, it is not flexible once it has completely dried. It is rock-solid/-hard!

How many square ft does one can cover

I did the bottom of my drift boat. Best I could figure was about 50 sq.ft.. Two cans did one coat. I put on 2 coats. A little hard to spread it out that thin, but it turned out real nice. I poured it on and used a roller with a thin napped cover, like the ones used for epoxy.

Can this expoxy be painted over? What is the actual color when dry? Thanks!

YesFrom their website.FAQSWhat is Coat-It and what is it used for? Coat-It is a 100% solids waterproof graphite black epoxy sealer and coating. Its original application is an armor plating type high build coating for the bottom of fishing boats, kayaks and canoes. Cured Coat-It creates slip and lubricity when the boat comes into contact with rocks, gravel or shrubs as well as protects boats from damage. Coat-It can also be used to create a non-skid surface on decks, steps or ramps by spreading medium to fine silica sand over the wet Coat-It. Allow to harden completely and remove excess sand. What surfaces will Coat-It work on? Coat-it bonds very well to aluminum, steel, fiberglass and wood surfaces. What makes Coat-It so tough? Coat-It contains ceramic beads for abrasion resistance, graphite for slip or lubricity and Kevlar® fiber (the same Kevlar® fiber used in bullet proof vests) for extreme toughness. What is the coverage area? Coat-It comes in both 2 lb. and 8 lb. kits. 2 lb. kit: 20 square ft.* 8 lb. kit: 80 square ft.* *depends on porosity of surface and thickness applied. What is the dry time for Coat-It? Mixed Coat-It should be applied within 30 minutes. Adequate dry time is approximately 10-12 hours @ 70°F (21°C) (less than half the time of competitive brands). Cure time decreases with higher temperatures and increases with lower temperatures. Thick coats cure faster than thin coats. Can Coat-It be used in conjunction with fiberglass cloth for additional strength? Yes. Use fiberglass cloth for added strength at plywood joints, etc. When using fiberglass fabrics, use a squeegee for smoothing and spreading resin. When coating large areas, use a foam roller. Using this type of roller assures a smooth uniform finish when applied according to directions. Can Coat-It be painted? Yes. For maximum ultraviolet protection, allow Coat-It to cure thoroughly, sand lightly and apply a good grade of marine paint or Famowood Dura-Tuff (above water surfaces only).

Brand	Amazing GOOP
Country of Origin	USA
Model number	5400040
Special Feature	waterproof
Specific Product Use	waterproof
Item Weight	953 g
Product Dimensions	10.8 x 10.8 x 19.38 cm; 952.54 g
Item model number	5400040
Item Height	7.63 Inches
Item Width	4.25 Inches
Are batteries included?	No

Amazing GOOP® Coat-It Epoxy 2lb kit

الوصف

المواصفات

لديك سؤال؟ انظر ماذا طلب الآخرون

الأسئلة الشائعة