Eastman120V x 2000W Straight Electric Water Heater Element High Watt Density, Hot Water Heating Element with Copper Sheath, Screw Mount & Gasket, 60124N

I wasn’t sure what i needed when I ordered but this element works wonderful

My only complaint is that they don't give any information on its size so I had to hope for the best when I ordered the matching bulkhead.. luckily it all fit

Element failed one month after install.

I got two ot these 1500w elements to replace my 3500w elements to reduce the load on my Sungold 240v split phase inverter when running on solar and batteries. Gets it done nicely!

The media could not be loaded. I used this to make a bucket boiler for cooking shrimp and crawfish boils in a 5 gallon bucket. To get it to fit through the 1" EMT coupling, I had to use a vise to slightly narrow the gap in the element at the end. The only challenge I ran into was that the supplied gasket deformed with even a little pressure applied and I couldn't keep it water tight. I removed the gasket and used a ton of teflon tape on the threads and got it water tight. After hooking up the lamp cord, I used hot melt glue to cover the wire and screws. Using a normal house 120v circuit and water that was 150 degrees out of the tap, it took about a half hour to achieve a solid boil with a half filled bucket.

Excellent replacement for RV hot water heater, quick recovery.

I used these in an unconventional way to make boil buckets and they worked great!

I bought 2 of these and installed them in my water heater. About a week later we realized that we were running out of hot water relatively fast. After further troubleshooting I discovered that the lower element was not working. It was past the return period so I had to buy another. This one seems to be working well. Maybe I just got a bad one the first time.