MK Morse Hole Saw AT25 1-9/16-Inch Diameter Carbide Tipped

Don't use it myself. But I sent it out with my field guys. Apparently they last longer than milwaukee Carbide tipped cutters. Looks solid straight out of the box. Not one complaint yet, not like any other new items I send out. Recommended

I cut 18 recessed light holes in 1950's plaster ceilings. By the 18th hole this saw was not cutting nearly as well as the first hole. I knew going into this project that this is not the proper tool for the job. A carbide grit hole saw is the proper tool, however, those are nearly double the price. Since this is a 1 off job the carbide tipped did the trick. It performed as expected.

I was going to buy a diamond tooth hole saw but this was cheaper and since I only had one hole to cut wanted to go as cheaply as possible. I was somewhat in doubt about the carbide tip, but it chewed right through the stone I needed to put a dryer vent through and the teeth seem as sharp as new after.

Price and quality is great, worked beautiful. Has the tiniest carbide teeth I've ever seen, triple-chip grind with three different profiles, cutting a narrow kerf that reduces counterforce, which is important with a hole saw this big.

Purchased for cleanly cutting cable holes in commercial desktops made of 1"-2" laminated particle wood, which it does extremely well without dulling or burning (unlike bi-metal saws which can only be used for one or two holes before they dull).

Husband ordered and uses it all the time and he seems to be pleased with it.This is about his 3rd Morse Hole saw he has bought over many years.

Cut the hole in fiberglass very good

I bought this to drill thru metal and then redwood siding for the installationof the tankless water heater on the back side of my house. I have a goodselection of holesaws but ones that could cut thru 18 ga (?) sheet steeland have any life left are not amoung my collection. This has some life left.