Universal Projector Stand | Height & Angle Adjustable Tripod 33" to 49" | Platform is 20" by 16" Fits Laptops, Computers, DJ Equipment & Projectors | Perfect for Stages, Studios & Offices | Black

**One thing to address before I get into my review. The negative reviews I've read concerning attaching the top plate/tray to the stand are, frankly, bogus. The screw is not welded in-- but it is firmly in there. Simply unscrew the thumb screw all the way off and tap the screw to release it. You might need to use a mallet or smack it with a wood block but it will come out. Then negotiate the top plate into position and reinsert the the set screw while being careful to keep the washers between the two halves. Screw the thumb screw back on, adjust the tilt of the plate to taste and tighten. Pyle probably should have included better instructions but they probably assumed customers would be a *bit* quicker on the uptake. Now for my review: Impressive stand. The metal poles are over an inch in diameter and the footprint if you fully extend the legs is nearly 30 inches (though you don't need to operate it that way). Suffice to say this stand is extremely sturdy and unlikely to tip over even if someone knocked into it. The plate up top is fully metal and not the plastic piece you find on most competitors. Height is not continually adjustable but adjustable via a cotter pin secured to the center pole by a canvas strap. Lowest height is roughly 35", then 42.5", 49", and finally 55.5". This will disappoint some but the cotter pin means this will hold a lot more weigh without risk of slipping. There is a lot more play/slop at the top height setting so I would recommend this at 49" or below. Laptops and smaller projectors won't cause this stand to break a sweat and the Pyle confidently held my 15 lbs BenQ X3000i which is not something I can say about the Innogear I bought alongside. About that: I bought the smaller tripod after I realized the Pyle might be too tall for my purposes. The Innogear is plenty sturdy for being so small and light but is somewhat let down by it's plastic tray table. It flexes and warps easily and I don't have much confidence in placing a projector much heavier than 7-8 lbs on it. Ultimately, I highly recommend the Pyle if it's size/height meets your requirements. You won't find a better tripod projector mount for the money (literally-- Amazon sells 'basically' the same thing for 50% more). The metal tray table and wide stance alone make this a winner versus the competition. I wouldn't try and balance a JVC on there but it should work for reasonably sized projectors 20 lbs or less.

I got the stand to use as a portable desk for my laptop. The picture showed my MacBook 16" on the stand. Plenty of space on the tray. I like it very much. If there is one weakness, that would be the tray is plastic. But not a big deal. The steel rod is 1.5" in diameter. It is really sturdy. But it is heavier than other stand. It holds my Epson projector very well. This is definitely super sized better than my other stand. With the lock, the tray stay raised to the height. Pretty happy with the Pyle stand. Not so happy about the Amazon warehouse though. I bought this item used, so someone must have returned it. There was missing parts. The screws and nuts were just dangling in the big box, not in plastic bags. It was missing a nut and a washer. Just bad that Amazon warehouse didn't check for missing parts. I could have returned it to Amazon, but decided to try Pyle support. I contacted Pyle for the missing parts. GOOD customer service from Pyle through email. They took my request as warranty service and shipped the parts. It took a few days to get from New York. One note was that the Pyle service representative asked me to take a picture of the missing parts. I supposed if the part was missing, how could I take a picture of the missing part. Anyway, I was glad and happy that they tried to help. At the end it worked out. I got the stand working. I also use it as a standing desk as well. 5-Star for Pyle standby their product 4-Star for Pyle customer service. 5-star for the quality of the stand.

The stand is much more stable and stronger than expected. It is heavy duty with very wide legs with a 2 inch circumference. So it's very stable even if bumped no worries. The top has a indent opening for the cord to go between. You can easily set up a projector, tablet or laptop. The height and the table are both adjustable to fit different needs. I highly recommend it. I was expecting something flimsy like the projector screen stand. This is high quality and will be very stable if you choose to use your projector outside. Can't say the same for the screen. Also it makes a great music stand and is much superior to any other I had owned. It folds down and the legs slide down and push up. The table portion fold down. No need to take anything apart for transport unless you choose to remove the table. Everything unscrews and the the height has an easy to use and remove pin to adjust the height.

I want to tell you..if the top of this stand was a little better it would be a Five Star review. Very heavy construction on the base and connection points. I believe that this thing could hold me if I stood on it! BUT..The plastic top is thin and I am going to have to beef it up a little. It is sturdy plastic, but it's only about the thickness of a normal cd case that you buy to listen to from the store. Mine was a little warped on the corners and it looks flimsy compared to this very well built stand. I suspect that I will cut a peice of 1/4 inch plywood to size and use the existing hardware to mount it. I am very happy with this purchase and the money that I spent on it. Very reasonable and the modification that I will make will be very easy for me. I would definately buy it again. The stand is built like a Sherman Tank. The top is an upgraded TV tray from the 70's. With the modification it is still WAAAAAY cheaper than other ones that I have seen.

Why did you pick this product vs others?: This item had a large platform area, a great, sturdy and flexible susable and is lightweight. Even though the platform is plastic, once it is mounted to the stand it is VERY stable and sturdy. The platform angle controls are very useable.

I put a 32" flat screen computer monitor on this stand. The tripod is very sturdy and I love the cotter pin adjustments that eliminate any possibility of the height slipping. I will say, the weight of the monitor is no problem for the tripod, however the tray itself flexes under that weight. I have it balanced and it works fine as long as it doesn't get bumped. I may put a piece of wood on top the tray to prevent the flexing. If the tray was metal (rather than plastic), it probably wouldn't do that. But, my application may be different than most.... I need to see my music in a larger format than that on a laptop when playing, hence the large screen. BUT, this is the only tray that is large enough to hold the base for my monitor, which is 18" (Tray is 20"-- perfect). I gave it 5 stars because it's a great product and most people wouldn't be putting some heavy monitor on it. Plus, it extends high enough to see past my kit (see photo).

Very well built sturdy stand...Not cheaply built at all. Mine assembled very easy, & did not have any defects whatsoever, as some reviews stated. It's made from heavy duty metal tubing, & is quite solid. The base where the projector/laptop sits, is made from some type of plastic with a rough surface which keeps my projector from sliding around even when sitting at an angle. I purchased this to hold my HD Projector, and it works great for this application. I can fully adjust the height, angle, & rotation of the projector, which makes it easy to set up most anywhere in the room. I originally purchased a different stand for $24.99, but it was quite flimsy, & not very stable, & for just a few dollars more, I figured I would try this one....You cannot buy a better built stand made from heavy duty tubing at this price....Very pleased with my purchase, & the quality of this stand for the money. Would definitely recommend.

Great sturdy stand that could be used for many purposes. It is not only height adjustable but could also be tilted if you needed to aim something on a bit of a tilt. I use mine for a projector, but I could see this being used for a lot of good useful things. It is good quality and for a very reasonable price compared to a lot of other products I have looked into before making this decision. I love that when it is not in use I can fold it up easily to keep out of the way and set it up in just a few minutes when we are ready to use it. The top is a nice size so if it was being used as a laptop stand it would leave enough space for your mouse or speakers and web cam or other accessories. I would recommend this product.

Ein stabiler Ständer, welcher nicht wackelt und mein MacBook oder meinem Beamer sicheren Stand bringt. Verarbeitungsqualität ist für den Preis absolut in Ordnung.

I am a teacher and have bought it for school. It's easy to use and to store. Different hights are possible and the projector cannot slide to any of the sides. It's something I would not like to miss in my class, and qualitative enough

Very good product

Molto buono

Muy sólido y práctico para cuando debo llevar el cañón a otro lugar para impartir clase.