2Pcs 2inch 4Ohm 10W Full Range Audio Speaker Stereo Woofer Loudspeaker for Arduino (Pack of 2) CYT1116

The speakers work and sound great. They fixed the blown speaker.

I liked that the speakers fit my charge 3 and sound was great the price on these where reasonable and well worth it if you need replacement speakers for your Bluetooth speaker

A little on the bland side for sound quality, but they're not bad. Better than the cheap ones that came in my PC speakers. That can handle a little bass, too.

These drivers are barely within spec to be used with the JBL Charge 3 as far as dimensions, the screw holes are way too big and the diameter of the diaphragm is just barely small enough to pass through the holes, however, I do not recommend these drivers to replace the OEM drivers on JBL speakers as there range is severely limited compared to the OEM and they can't handle nearly the volume, if I push the speaker past half volume there's a nasty rattling that worsens when any type of bass is present. Bass also makes the drivers rattle at lower volume levels as well. Where these speakers shine though is in the mids and highs and at moderate volume levels.

DO NOT Substitute these speakers on your JBL Charge 3 They sound the same as my blown speakers Original screws were to small for speaker holes so I had to find screws that wouldn’t go through the holes VERY DISAPPOINTED

1. It's the same 2inches, 4ohm with 10w (a bit wider or thicker than original from back casing but Fits) 2.the shape of the original is kinda rounded from center areas with gasket (the replacement is straight square without gasket, so i had to peel it from the original) 3.Screws fit just right spacing 4.worked great and sounds just like the original once installed May look different buts sounds the same (if replacing to resale will be obvious that was replaced since they look different) but souds wise will not make a difference... Note... have 2 linked to compare sound with same song playing and they are just perfect playing at the same time (can't tell which one is been fixed)

Slightly less powerful than the ones that originally came with my logitech speakers, but the closest ones I could find as far as wattage and impedance. The difference it's not even noticeable at higher volume. Plenty loud and clear! A little modification to get them to fit but it's a great replacement.

I used this to replace a blown JBL speaker and I would buy elsewhere. The holes for the screws are too big so you can’t screw the speaker down tight, the screws go through. It also doesn’t have holes for the positioning nubs so I had to cut the nubs off. It still didn’t sit 100% flush.