Bohning Insert Iron, 1 fl. oz

The item was as advertised. I would highly recommend. I had trouble with the inserts on my arrows coming out when I pulled the arrow from the target. I tried every kind of glue out there and then saw this. I bought a tube and tried it out on a dozen of my arrows. The results were excellent!! I applied the glue with a cotton tip swab to both the inside of the shaft and also the outside of the insert...use sparingly...you don't need much. Twisted in the insert and let the glue cure for the maximum time of 72 hours. No mess and the extra cure time was no big deal to me. Anyone into archery, I'm sure, has more than a few extra arrows to use while the glue cures on the ones fixed (even though I could have used the arrows after a cure time of 24 hours, I chose to recommended max time). Glad I did...the results were worth it!!! I use carbon arrows and the glue being used has to be made for carbon...which this is. Good stuff...will always use it.

So far this stuff has proven to work great! Tips are not coming out when pulling from targets.

It seems to hold very well, but it expands a lot, even if I only put a little bit on the inserts it had expanded out onto the shaft overnight on several arrows. It was not that hard to clean off so not a big deal. I also wonder if this impacts the balance of the arrow if the expansion puts more of the glue on one side of the shaft than the other. If it does it likely does not impact accuracy noticeably. I will say that since using it I have not had an insert pull out ever so it holds rock solid. If you are using carbon arrows make sure you clean the insides of them first, typically they have a lot of carbon dust in them, and if it's left there it won't allow the adhesive to stick as well. As someone else mentioned another good tip is to screw points into the inserts in advance, it keeps epoxy out of the insert, and gives you something to grab onto when you put glue on them and install them.

Been using on black eagle arrows for years. Works great, holds firm, little bit goes a long ways. Great value for 1 oz!

This is first time using this although a long time hunter and i cut my own arrows this is amazing compared to what i used before strength is amazing. My only draw back is set up time but small compared to finished product

Epoxy failed. Hot glue is a mess. Super glue doesn't last. This stuff is easy to use (although you have to give the bottle quite a squeeze) and has not failed me. I dip the insert in water (you're right most of it rolls off) and insert and remove it from the arrow prior to applying, since this type of adhesive like a humid environment. Then insert and shoot tomorrow.

Whoever says you can use hot melt on small diameter carbon arrow inserts is full of it. Using this is much easier, and I no longer have inserts getting stuck in my targets. Highly recommend with Victory VAP SS!

Worked good until it dried up about half way through