Supreme Suspensions - LED Light Brackets for 2004-2014 Ford F-150 Upper Windshield Mounts for Base & Raptor Models - Can Cooler Included with Purchase

Just what I needed to complete my installation, perfect. Great product.

It didn’t fit the light with my truck.

Works as should wish it had rubber on the bottom side over the door puller part to help with wind vibration but all n all good product

These are very nice looking. Unfortunately, the light bar vibrates like crazy. I thought the angle of the light might be incorrect, so I adjusted it MULTIPLE TIMES.. the wind also whistles through the design cut outs. I installed a section of black rubber under each bracket where it meets the window, this stopped the wind whistling. Unfortunately, nothing has helped the vibration. It may be the light! It wasn’t the most expensive one I could have purchased , therefore, it makes me think it could be the culprit of the vibration...I was not impressed with the installation hardware. Unfortunately I used their install hardware on the. 1st side. I then decided it wasn’t the best way to install the light brackets to my truck and it required drilling large holes. I chose rivets and self tapping screws on the passenger side. This side is much tighter and sits very flush> I preferred this method and also the pre~drill holes are considerably smaller. This will be nice should I decide to remove the light bar.With this in mind, I STRONGLY RECOMMEND USING RIVETS & or SELF TAPPING SCREWS TO ATTACH THE LIGHT BRACKETS!Regarding the vibration, The Side with the rivets does vibrates less. I am considering making some rubber spacers to place underneath the brackets at the upturn junction where light is attached. I’m very hopeful this will stop most, or all of the vibration..If it doesn’t help, I’m going to ditch the entire setup. I don’t want to do this because the brackets and light look fantastic and provide a great source of light. I’m a contractor, and often work after dark. It’s been super to not need a drop light for loading tools into my trailer at night, or to finish up an outside painting job.All in all I am very pleased with the brackets and I do recommend them_ .**note` Prior to connecting brackets to truck, I filled the pre~drill holes with silicone and gasket sealer to ensure no water could penetrate the body of my truck.

I have a 2007 ford f150 and these 50 inch brackets did not fit correctly. And does not come with any sort of directions. I will say they are nice thick metal and I am sure they would be sturdy. And the powder coat chips easy on the edges but is very tough on the face of the brackets

Best mounts out there

Definatly not for a Ford f150 of any year not for 52 inchs.Arrived scratched and rusted asked for a partial refund was denied, put them up on the truck (2012 f150) from the door in on both sides they go in about 6 inches. That's 12 inches total, no 52 inch would ever fit that. EVER! Measurements with the tape measure was about 38 inches of room to install a light bar on your truck roof....

Heavy duty made great

Good