Junction Box, Zulkit Project Box IP65 Waterproof Outdoor Box ABS Plastic Electrical Boxes Electronic Enclosure Black 3.94 x 2.68 x 1.97 inch (100X68X50mm) (Pack of 2)

Dimensions and specifications are accurate. Worked great for my application. Fast delivery too.

I bought this to house a time delay relay to switch on an external hard drive 10 seconds after the computer is turned on. Solid case with a cover gasket. Very reasonable price.

Nice little hobby boxes for the price. Shiny finish, they drill fine, and have good fit and finish. Used to add a couple switches to the tractor using an existing bolt so as not to make holes in the dash. Would buy again

Nice project box, but the rubber gasket cord is a pain and takes some time to push into the cover. I'll probably get a box with the gasket already attached next time. Otherwise, it is durable, and once you get the gasket in the lid, it should be fairly water tight. The lid screws have metal inserts to screw in to, so can pull the lid down good and shouldn't strip out. The box itself is fairly thick plastic, so should be very durable.

Bought this little box to use on a boat. Comes with a gasket and seems like it keeps the water out pretty good. Out of precaution I did drill a 1/8” weep hole in the bottom just in case any moisture gets in.

Heavy duty box. Works as described.

I really like these project boxes. Their durable, easy to drill, and lots of size choices. I also like the metal threads and machine screws instead of self-tapping screws into plastic. Lots of room inside with no partitions getting in the way. I'll be ordering more of these in the future.

Enclosure purchased: "4.5 x 3.5 x 2.2 inch" I typically make my own enclosures but I wanted to buy one this time. This enclosure is nice, the finish is a mild/moderate gloss, it ~seems~ well-waterproofed (my application won't be submerged), and it came with multiple standoffs built-in. The enclosure I bought (here in January 2023) had 6 standoffs. One in each of the 4 corners, and one centered between two on either short end. I just cut off the middle standoff on one end for my use. The schematic for this enclosure appears to be accurate in measurements (aside from standoffs not matching the photos, but I didn't expect standoffs to match my circuitry in this one anyway). My circuitry didn't match the standoff pattern so I made my own. The enclosure top and bottom thickness is 3.8mm and I was able to drill+"tap" holes for some motherboard standoffs, without drilling through the bottom of the enclosure which I was happy about. I used a drop of JB Weld on each to be sure. I appreciate the thicker bottom and top. My only wish would be covers for the screw heads on the enclosure's top. The bright shiny metal messes with the color flow. But paint or even a Sharpie should help, it's not even worth listing as a con. I'm just getting started with this enclosure but it seems like it'll be exactly what I was looking for.