4 Pack Locking Hinge for Folding Table Brackets, Heavy Duty Folding Brackets 90 Degree Self Locking Folding Hinge for Table Legs Furniture

easy to use and very stable handles heavy loads easily

I love the Value I got from this product. The gold Aesthetics of it is awesome & it is Very VERY Sturdy. As you can tell from the video, it requires some pull with ONE hand. Overall it is a very awesome product and will buy for my next project if needed ! Thank you ! I know my way of installing was different, but, this product saved me.

Great hinge. Locks and holds up well. But throw away the screws and get real ones. Use #8. 3/4 or 1”….

Worked out great. Easy to install. Sturdy product.

Heavy gauge steel, a bit stiff at first, but that will smoothen itself over time. Some reviewers were complaining that the top mounting holes are obstructed by the locking mechanism and springs. Don't listen to them, they clearly don't know much about DIY or mounting hardware in general. The holes are indeed obstructed when the hinge is in open position (duh!). All you have to do is to close it and the top two holes become fully exposed. So yes, this thing will take a thought or two to figure out the sequence of steps and what you mount first, second, third, etc... Just dry fit it all first, pay attention how far beyond the top of the hinge your leg will extend, then think through your steps in chronological order. It's a good hinge. The screws are merely OK (I'd replace them, with something heavier gauge), but they are serviceable. Pre-drill pilot holes into your wood too for splintering prevention. It's a good set of hinges and I'm looking forward to mounting folding legs on my murphy bed and mounting fake light lamps as a decoration to hide the leg itself. This is precisely what I was looking for.

Excellent product excellent service Excellent excellent shipping.

I installed using the screws provided, but when I tried to fold the leg, it ripped the two screws closest to the fulcrum point out of the table top and bent the hinge where the other two screws were screwed into the table top. Yes, I did unlock the hinge before I tried to fold the leg. These hinges are just too stiff. OK, I finally figured this out. In their last picture, they have an arrow with the words "Press to fold". The problem is the arrow is pointing in the wrong direction. If you press in the opposite direction, it works. I also had a problem with the provided screws: the head popped off one of the screws as I drove it into particle board. I did drill a pilot hole before I attempted to screw it in, so I was disappointed in the the quality of the screws.

Works great. Need to make sure you have access to unlock hinge. I can see applications where that could be a problem. If you can reach the hinge, you probably will be okay. Appears to be durable and of good quality.

Good product works well

Bracket is not exact 90°. 180° and 0° are accurate

Surprisingly solid. I used them for legs of a Dias (stage) only challenge was that if you have long lengs, they prevented it from locking shut (about 20 inches) At one point I tipped the stage onto a leg and the screws pulled out of the wood rather than these units being damaged.

Alles sieht gut aus

Product was very difficult to open/close while holding 1/2 of a 3/4" sheet of plywood in the horizontal position. Excellent product, just not appropriate for my application.