Panel Bonding Adhesive, 38315, 50 mL Cartridge, Two-Part Epoxy, Used On Plastic and Metal Substrates

Works great

This is a very strong adhesive. It is very tacky and grabs immediately. It is difficult to slide the mating sides around once the two sides of adhesive make contact. That's just something you need to be very aware of. But this is very good stuff. I will use it again.

I've used panel bond before for various things and it was the first thing that came to mind for this job........fixing broken headlight mounting tabs. And it freaking worked. Saved a set of aftermarket headlights for one of my vehicles that were picked up on a whim for dirt cheap because they were broken at the tabs. They're now mounted and holding up great. BUY EXTRA NOZZLES if you're going to do a small job like this.

Good stuff. Tunes are pretty small. Not much product.

Worked great for my metal to metal bond.

Follow directions and you will never use your might welder for joining panels as this holds just as well (or even better) without burning protective coatings which then allows rust to form. You do need to grind any coatings off from the two adjoining surfaces providing a bare metal roughened surface for a good bite. The panel adhesive forms a waterproof barrier where moisture cannot get to the metal surface. If it does, you are not using the product correctly. I use a few sheet metal screws as needed to hold the panel in place until the epoxy cures. A small amount of adheasive should ooz out along the seam edges ensuring that you have used an adequate amount. Then I grind the heads off and roughened the surface around the seam then apply a good quality waterproof short stran filler. Shape, sand and finish as needed. Been using this product for years now. Had a small quarter panel patch repair to do on a 1995 Toyota. This was just the right amount to do the job.

Purchased the item and not eligible for return. It’s much smaller than the item I believed I was purchasing and tried to return to purchase the correct item. They will not return the item. Be aware of what you’re purchasing before you buy this item.

Excelente producto, necesitas una pistola para su uso y es un cartucho pequeño, no da para mucho

初めて使用したけど良いと思う

Great product, just what I need to glue on a cab corner on my jimmy. Proffesional grade, a little expensive but cheaper than the alternative.

使い切れるボンドの量が、良かったです。

Took forever, and I would need 3 of these to glue a quarter panel on , real tiny

溶接できないので、パネルボンドを使用しました。トラックですが濡れない場所でしたので。 容量が足りないかもと思ったんですけど、案外いけました。 主剤と硬化剤をうまく押し出せないので、後ろのゴム部分を 直接押して板の上に出して混ぜて使用しました。 接着力は問題ありません。ガッチリつきました。