1" Yoke 10" Laminated Tire Finish Mower Wheel Assembly 2 PACK

The original wheels on my Bush Hog finish mower wore out. These are much heavier duty than the OEM wheels. The yokes are made of thicker steel and the wheels are much sturdier, similar to the wheels on my field brush mower. Got a discount on signing up for Prime when I bought them that was more than the cost of a year's Prime subscription. Guess that downside is that was 3 years ago and for 2 years I've continued to pay for Prime membership. If you use Prime enough, for someone like me living 15 miles from the closest town with significant shopping, the cost of membership is offset to some extent by need for fewer trips to town.

Item was correctly described and fit perfectly on my Land Pride finish mower. Very well built. Easy to install.

Worked great. Well made.

Fits my landslide fd2752 finish mower great replacement easy install

These wheels are solid and durable.

I have a pretty new Kioti Finish Mower deck and ALL of the wheels are falling apart. Big chips in the rubber wheels and one actually broke off the rim. (pretty disappointed with the manufacturer on that one) Otherwise the mower deck is pretty good. The wheels on the mower deck are 8 inches high and rated at 300KG per wheel. I had decided there is no way i was going to replace the 2 year old wheels with the same thing since they failed with hardly any use (under 50 mows). I was concerned that a 10 inch wheel would not fit the machine correctly and would hit the deck while turning or backing up. I gave these a try. The fit and have clearance to fully rotate. Tested them on over 15 acres of grass. No problems. No divets/tracks. That the good. The bad. My deck has bushings that the wheel shafts need to fit in. The bushings are pretty tight tolerances. One of the shafts was deformed by around 1/32nd of an inch where the securing pin passes through. I had to grind it down a little bit to get it to fit. The other shaft was just fine. Since you cannot easily put this thing on a lathe to true it up, you need to be somewhat careful in doing this work. Overall this was a pretty minor flaw but something the manufacturer should pay closer attention to. It did add about 1 hour to the installation task. The second one took only 5 minutes because it did not have the same problem. Manufacturer.. if you are reading. QA should do a test fit in a receiver that has top and bottom bushings and a grease fitting in the middle. That simple test would have probably failed and would only take like a few seconds to do before welding up the wheel assembly... and more importantly, while it is trivial to fix. Update ---------------- I ordered a second pair of these and had the same issue I had with the first. One was not entirely straight. It was very very close and has since worked/worn itself in so that it spins like it should. The first pair was worked flawlessly since they worn in. No issues in over two years. The tires I replaced were destroyed in less than two years....so these are way better than the originals.

Perfect fit for the county line 6’ finish mower, better than the original. Arrived in very short time. (May not be compatible with some tractors on the front wheel location. On my Kubota L3940, there’s not enough room for these large diameter wheels without interfering with rear tractor tires when lifted.)

The price for the two of these was very reasonable. It not only has the wheels, it has the entire assembly with spacers. I like the wheels are made like a bush hog tire and should last longer than my last solid wheels.