uxcell Motor Fan Blade 116mmx14mm Round Shape Bore Black Engineering Plastic with 12 Vanes

I bought this knowing the dimensions of the shaft hole were smaller and the fins may extend to far out - which was correct. I just ground the adapter on my drill press motor to fit the blade tightly; and I cut the fins down about 1/4" - to fit motor cover. It works fine now. I gave it a five cause it works fine and is sturdy enough - it does what it's meant to do - with maybe a little modification.

It was so easy to replace the old fan with this part. A snap!!!

I used this to replace the fan on my pool pump motor. Though not an exact fit, it did the job. It has some flexibility on the shaft diameter size which helps.

I made the mistake of buying an air compressor from harbor freight. 4 months in the engine seized up. Took it apart and the fan blade melted in the center and then froze up sideways. I would say it wasnt tighten during assembly at factory. Anyways, I pried it off and put this blade on. Been going well a couple of months now.

Junk, broke within 1 minute of use. Dont buy.

Worked perfectly

Put this on an old Delta AP400 dust collector motor that was seized, after I bent the original fan off the arbor to repair the motor. This fits great, has a little flex, and pushes a lot of air over the motor case.

I used this to a replace a broken fan on an old motor. The dimensions were correct, the material is appropriate and the molding was pretty good. I did clean up some mold flash and machine down the provided spacer to get the clearance I needed, but these were minor things and particular to my installation.

As advertised look like it should last a long time

great fit, hope rubber bushing for the 14mm size holds