12S (Red)

I removed the mechanical pump on my 327 small block Chevy. I put this under the frame. I installed this a year and it's functioning fine. This electric fuel pump which is low pressure to be used with a carburetor solves a lot of starting problems. Ditch the mechanical pump and Get this!!

Mounted to a piece of wood and used as a transfer pump for a gas tank. Worked well pumping the fuel as long as the pickup hose didn’t go too high above the tank. I was also able to pump the water out from the bottom of the tank with this pump.

Does everything I want for my Holley 650 4 barrel carburetor on my truck -1975 IH 1600--------------------I have been asked a lot of questions by people from Amazon about this fuel pump.The biggest question I get - will it work on a particular model. Sometimes I can answer that question, while others are not sure. When it comes down to carburetors each has a certain PSI for fuel pressure rating. These need to be match. If a carb is rated @ 6psi then the fuel pump should be @ 5 PSI or a little less . If you get too much PSI, the float in the carb WILL NOT shut off. This will cause the carb to flood fuel everywhere in & on the engine. Not enough PSI might cause low fuel delivery. The other item is GPH {gallons per minute}, in most cases this is not important issue, unless you got a rocket vehicle that needs massive fuel delivery. Also I have been asked about the mounting positions, I always try to mount it feet down and also close to the fuel supply {tank} as possible. A general rule to any type pump, it can push liquid farther than it can pull it {from tank}. Hope this helps.

It ran for 20 minutes pretty well then it died forever. Used it to suck bad fuel from a fuel tank.

The media could not be loaded. @weaverstonehousefarm on YouTubePressure is 7psi on my gauge in the video.Even at full throttle on my IH 444 tractor it works fine. The bolt holes line up with the factory pump holes.It has a 5/16” smooth barb outlet connection for a rubber fuel line. It’s can’t be removed or replaced.I wish that outlet was threaded. There are other models with a threaded outlet.Inlet is threaded. Possibly 1/4” FPT.I got tired of every 3-4 years replacing the $60-80 dollar pump from NAPA.For the twenty something dollars it will work and looks similar.I tried this higher pressure pump as the 2-3 psi pumps would barely put out 2psi.Wiring was simple 12+volt DC positive and the ground wire to the bolt for the base.It comes with mounting bolts.We make hay and run our equipment in the worst and hottest parts of the summer so it’s expected that and electric fuel pump w/o any external cooling will eventually fail for us. It gets so hot sometimes when making hay the fuel will boil in the tank.

The same as an Edelbrock pump only one third the price

Nice pump!

muy buena