G Clean AP31024D High-Pressure Detergent Injector

It's cheap. The clear part cracked the first use. I tried to use some epoxy to seal the crack but the whole thing just exploded after. Complete garbage!

the design is great ,the hose fittings are well made , but the plastic cup seems strong but the first one cracked in my hand while switching from water to soap like the tank could not hold the pressure of the water going into the soap compartment I asked for a replacement and it worked great three times until again while using it I noticed soap leaking out and looking closely found a tiny crack right by the top of the plastic cup Also the one I received both times had a side mounted soap reservoir not like the one in the picture ,I mention this because the problem seems to be the plastic cup and since the side mounted one has a cap on the end I think it has a design flaw

Replaced my Salt Away dispenser and is MUCH better for flushing my boat engines.

split the second time i used it not very rugged but worked great till then waiting to hear if they will replace

Not as good as they say is all ready starting to leak at seem

NO! Just slowly scroll down buy something else and no one will get hurt.Bought two of these and they lasted 2-3 min each, container bottom broke making them useless.First one completely separated second unit cracked.The hose supplied with the units is a joke , to small to allow adequate water flow

Broke it, I wish the plastic cylinder have some padding to prevent it from breaking easily

Out of despiration I tried this product and was hoping for the best. Unforunately, there seem to be very few options for an upstream chemical injectors on the market. This one is not worth the effort. The chemical holding tank is far to small for any reasonbly sized task. The tank runs out of chemical within several minutes, requiring the operator to interrupt work constantly to refill. The tank is also directly fed by the incoming water, making the chemical concentration less and less over time. This provide an inconsistent delivery of chemicals as you work. The adjustment knob is unworkable, since it seems to either be "all on" or "all off". Others have complained about leaking. I couldn't care less about leaking, if this thing wasn't such a major hassle to use. I think I will try the Sutton injector next. I will be sending this one back.