150 mm (6”) Inline Bathroom Extractor Fan with Run-On Timer – Quiet Loft-Mounted Ventilation for Shower, Toilet & Damp Control

Powerful, quiet , well made , value for money , Easy peasy to wire in -no earth required just Live Neutral A second switched live ( activated when you switch on light inside shower cubicle ) Mounted mine on some foam ( kids play-mat type that you clip together ) ,just cut it to size job done . Thoughtful touches included were spare plastic tensioners for the straps that hold it to the cradle (should they break in use ) A dedicated plastic timer adjuster that is like a small screwdriver I have taped these to the fan in a bag so they are never lost and handy if I ever need to adjust timer. Overall very impressed it’s powerful , very quiet and the timer run on after you have switched off can be adjusted from zero to around 30 mins . I’m using this in really cold weather and there is zero steam escaping the shower cubicle the bathroom mirror does not even steam up and it clears any very very quickly . I suggest attaching the hoses with aluminium tape as it’s solid seals very well and is weatherproof , used by HVAC pipes fitters it’s good stuff . Also 100% recommend from me .

Brilliant, easy to install following instructions and works well, the mirrors used to be fully forged up with my old one and now don't show any fogging

Easy to install. Seems to work fine. Warranty registration a bit bothersome - it's on the Blauberg site (so this is a Blauberg fan, which I'd guessed) and requires the serial number which I can't find on the box or paperwork, so will have to climb into the attic again for it. Note that the noise level per the fan rating isn't what is shown on the Amazon listing (others have commented on this), but it seems quiet enough.

Installed to remove steam from a shower. Best features are: Removable leaving all ducting in place, so great for future servicing/replacement. Quiet running. Integrated overrun timer. Dual speed. My experience: Works well and is fairly quiet though I mounted it onto a beam and sound is conducted to the house so I will remount onto a foam pad to silence it completely sometime. Sound is not intrusive though. There are some reviews mentioning water getting in to the electronics but it is down to how you mount the unit and the ducting you use. This time I mounted it vertically with minimum amount of ducting, venting to a vent tile in the roof. I would say avoid uninsulated ducting as you will get condensation inside which will lead to water ingress, especially in winter months. Keep the runs short as possible and with a slope so condensation cannot pool in the pipe. Better for any condensation to run back into the shower where it is already wet rather than anywhere else, though I see no water as the 30 minute overrun probably dries it all out. The low speed doesn't seem to be much slower but is a little quieter than full speed. To reduce noise especially for night time, I wired a relay into the unit so it runs full speed when the bathroom light is on then low speed for 30 mins when the light is turned off. Seems a good solution. You should definitely incorporate an isolation switch so all lines can be disconnected for servicing/replacement etc. Good product - would buy again.

Great fan unit. This is my second one of these and I've replaced all Expelair noisy contraptions with these quiet and well behaved in-line units. They're more powerful - you can feel the draft under the bathroom door - and have operated for years without showing overheating or sounding like having a Cessena stuck in your bathroom wall. Check out the fps ratings (cu ft per sec or farts per sec?) I think they're safer. Some of the cheaper wall units just use a large resistor in their circuits that can get hot and age - not good. These units don't have that issue. Don't forget to buy a multi-pole fan isolation switch, 3+1 mains cable , lots of pipe and fittings and make sure that its all fitted correctly - use a professional (electrician) if uncertain or illegal to DIY.

Works great, took 20mins tops to install

Good quality piece of kit. Excellent value for money. Comes with good clear easy to understand instructions. Would certainly recommend.

This fan is easy to fit with good instructions available however I was unable to get the run time on the electrical switch to work properly. Good value. Will be ordering another

لا يعمل

Gran flujo de extracción de aire pero en mi caso, nose si por defecto de fábrica o es que esta diseñado así pero por las uniones centrales se escapa gran cantidad de gases, humos o lo que estés tratando de extraer, con la consecuencia de que se te llena la habitación de lo mismo que tratas de extraer. He pedido otro nuevo por si acaso es algún defecto (aunque no lo parece y tiene toda la pinta de que está mal diseñado) y si vuelve a pasar, lo cancelo de nuevo.

Cumple con lo mencionado y muy silencioso

تسحب الهواء بشكل جيد ولكن صغيره الحجم وبلاستيك خفيف

De momento funciona bien y me parece suficientemente silencioso