(4 Pack) PGN 5/8" x 1-3/8" Flanged Ball Bearing - Replacement for Lawnmower Wheels - Chrome Steel - Lubricated

This wall plate has a simple, modern look that fits nicely with updated outlets and switches. The finish is smooth and even, and it feels sturdy rather than flimsy like some cheaper plates. Installation was easy, with screw holes lining up properly and the plate sitting flush against the wall. Once installed, it gives the outlet a clean, finished appearance without drawing unnecessary attention. If you’re replacing old or mismatched plates, this is a well-made option that does its job while looking sharp.

I was really impressed with the seals and the heft of the bearings. Heavy and thick, very tight rotation meaning no slap back and forth so good tolerance controls. Smooth rotation. Had to get this to replace a failed bearing for my tracer ex2 wheelchair caster fork which made it extremely difficult to turn or swivel. Had ordered the bearings that amazon listed as correct for my wheelchair (also purchased from Amazon) but those bearings were not big enough. If your inside diameter is 5/8 inch and the cross width is 1 and 3/8 inches for the bearing body and the lip or flange is about 1 and half inches then this should work for you too. I was so impressed with this bearing i went ahead and replaced the other 3 bearings in my wheelchair even though they were still working you could feel they had a little give back and forth. Now my wheelchair is smooth and so easy to maneuver. It's described as being used in minibikes and lawnmower and I believe this bearing will perform very well for that. So I wholeheartedly recommend this product. The other bearings I ordered weren't as quality made as these were but their biggest problem was that it would not work even though the manufacturer pdf parts list says it should work for most models with the note to verify actual fit. Those were 1/2 inch inside diameter and only 1 and 1/8 inches across the bearing. Hope this helps someone else. Good day

March 1st, 2026: Installed these 5/8 x 1-3/8 flanged ball bearings on a gorilla brand wheel barrow (16") tire and wheel I bought from Home Depot. Fit in the wheel perfectly and it fit snugly on the 5/8" wheel barrow shaft. Wheel spins very nicely now. I plan to update this review later on after these have had exposure to the elements.

These worked great as replacement wheel bearings for my bad boy 2010 mz magnum 48 inch 27hp. They're a little heavier duty bearing than oem.

very nice and works great

Very clean / smooth turning bearings with rubber seals on each side. Going to use it on my wheelbarrow.

bearing worked fine. only thing i will say is to carefully remove the plastic bearing seals on both sides with the tip of a utility blade. wash out the clear whatever type grease it is with carb cleaner, brake clean or parts cleaner.. i repacked with high quality synthetic grease. wipe off the extra grease. then just pop the covers back on. also be careful when driving the bearings in. i first tried a socket with extension and the lip of the bearing cracked. tossed it away then used another with a bearing driver tool. its just the bearing is so small and the outer race is very thin. once in they work great.

These bearings are a perfect fit for the Zero Turn, Kubota Z121s KH-48 Kommander. I used them to replace worn bearings on the front wheel axles. I would say they are an adequate product for the price. I expect they will last 4 years and 400 operating hours. I would buy them again.