Open Frame Generator Tent with Universal Clamp System - Waterproof and NFPA Flame Retardant Running Cover - for Operating Open Frame Generators in Wet Weather (Slate, Original - Standard)

I've been thinking about getting a cover for my portable generator for some time, to allow me to run the generator while it is raining. Doing some research online, this company stood out as a great quality. After ordering I promptly received a message from the seller to confirm my generator model to ensure I purchased the correct one. After confirming it was correct, they offered to take a look at photos to verify it was installed properly. Installation was simple, took less than 10 minutes. The instructions were clear, detailed and had pictures to verify it was done correctly. Since I have not had the opportunity to test it yet, I cannot provide feedback on that. However, the material feels very durable and I would not expect water to get through. There is also a detachable flap to cover the outlets and an opening to refuel without having to take the canopy off. I'll update the post after I get some time using it.

GREAT COVER FOR MY GENERAC! Needed a weather cover for my 8500EFi Genrac and after doing a little research Gentent was the product I needed. It was easy to put on my generator and protects it from all weather types.

So far... It is easy to put on, I have only used it one time with hurricane Milton. I live in the Tampa region when the hurricane came through. I had the generator on my back covered patio 15x30 ft. The wind started whipping through and the power went out at the same time and it's dark. I put the gentent on and it kept the rain off of the vital parts of the generator. The next day the power was still out but the storm had pasted. I moved the generator out of the patio to the natural gas hookup. It was still raining but not hard. It worked fine. I have not had to run it outside of the patio in the middle of a hurricane/storm yet. However, I feel I'm as prepared as I can be with what I have. I did build a temp concrete black wall on one side of my house. So hopefully between the block wall and the tent I will be able to keep the generator running for the next storm. The tent is on the expensive side, however, it does seem to be well built. It worked very well with my Firman Trifuel.

Fits perfectly, easy set up, folds away for compact storage. Haven’t had to use it in the weather yet. Much cheaper alternative to permanent hard enclosure. This style will not dampen the noise much but offers adequate protection from rain and snow.

I installed this on a Duromax XP13000HXT Generator. The cover is thick material and seems like it’s high quality. It covers all the essential parts and looks like it’ll hold up very well to the weather when needed. Duromax uses a squared tubular frame which will require you to ‘adapt’ the frame by installing the included mounts to the frame. This involves drilling pilot holes, then using the included screws. I drilled 5/32” holes per the instructions and my first two screws stripped out completely and wouldn’t go in. I went up to a 3/16” bit and didn’t have any other problems. I took my time to carefully go through the motions for installation. I wouldn’t say it was difficult, but I’m glad I set it up ahead of time vs scrambling in a storm. All in all it’s a great addition to my generator to ensure I can have power continuity regardless of the weather conditions outside.

Customer service was great by phone in helping to determine best size for my DuoMax (Amazon dimensions for DuoMax XP13000HX generator are misleading as the specifications are shipping size, not generator size. You should measure your generator to determine which GenTent you need). GenTent assembly instructions and videos are great and even addressed specific instructions for my DuoMax. The design of the tent leaves room on top of generator for storage of my generator accessories (when generator is not in use). I purchased the optional clear vinyl apron for my GTOPFUAEBK Extreme Cover. I used the included black apron cover to wrap futher around the tent , being careful not to get it close to the exhaust, as specified in the installation instructions. The tent and mounting accessories appear to be well made and should be durable. I highly recommend!

Mark @ Roanoke This is a game changer as it’s light, quick to install and durable. Keeps my generator noise-free outside my garage w/ door down.

High quality product. I haven’t used it in a storm yet, but I have no doubt it will do the job. I sa another reviewer mention they were glad the installed it before having to do it “under the gun” during a storm. I agree! It takes a little time to get it right. A special shout out to their customer service, it is awesome! I purchased the wrong size for my generator, totally my fault. By the time I discovered this, I was outside the Amazon return window. I contacted them and the provided me an opportunity to return and replace with the right size. That process was exceptionally smooth. They are properly focused on customer satisfaction. Thanks Gentent!

The Gentent generator cover was easy to install and stood up well to a heavy snowfall, high winds and rain.

Great value for your money. Very sturdy and easy to set up

This works so well in keeping the elements off and away from the generator when the weather is wet, and windy..It should prolong the life and appearance of the generator for many years, where it is not exposed to the outside elements.. Goes on easy, and looks really nice once installed.

My generator is very well protected ...We love it ... fits perfectly on our 12500 watts Champion generator. Thank you everyone who invented it ,and plus it looks good !

My husband said it worked great to keep rain out.