Car Door Edge Guards Clear, 32Ft Rubber Seal Protector U Shape Edge Trim Car Door Edge Protection Fit for Most Car

Soft, pliable, cooperative, easy to cut to size. On a somewhat warm day (for pliability) and with patience and the following method, it fit/butted up perfectly, along a ridge/rim on the inside of the door. I trimmed to length & fitted the product along the entire edge, (I put red strip on the inside.) Started at the top, used my fingernail to lift a tiny section of the soft, inside edge; gently pulling off the removable red strip on the adhesive; an inch or two at a time. (Only the inside portion of the strip has adhesive.) Then I applied even, medium pressure on both sides and the turned, outside edge of the strip; in a pinch/press (no sliding/stretching) motion- again a few inches at a time. I was careful to neither stretch or scrunch the length of the strip at any time. The product is almost clear, but has an ever-so-faint violet tinge to it in some lighting; but it was not a deal breaker for me. It attached firmly and evenly; along the inward and outward curves of the door. It’s been on for a few weeks and car washes; It’s been really hot, and has stayed attached. Some moisture does seep in under the outside edge; and a neat, hairline of fine dirt accumulates along the outside edge. Since the dirt is about the same color as our beige car it’s not obvious. BTW I put a very similar product on our older car doors over 10 years ago. Although it also gets moisture underneath, and the same hairline of fine dirt accumulation, it has remained in position through numerous car washes, rainstorms, wet roads, severe cold and heat; AND has prevented damage to our other car. I can’t speak from experience; but I imagine that this edge strip is removable, if needed, since it remains in a somewhat pliable state.

As a proud owner of a new car, I couldn't help but worry about these EXTREMELY LONG doors. I mean these doors are HUGE and open so wide, I really worried about hitting the car next to me in every parking lot and in my garage at home. Thankfully, I discovered the Car Door Edge Guards, and boy, have they been a game-changer! From the moment I received these nifty protectors, installation was a breeze. No complicated tools or frustrating instructions—just a simple U-shape design that effortlessly fit along the edges of my car doors. Kudos to the genius behind their user-friendly design! I've had these edge guards on my vehicle for over a month now, and they have proved their mettle. They not only safeguard against those pesky parking lot mishaps but also shield my car's vulnerable edges from any unforeseen surprises. One of the standout features of these guards is their crystal-clear appearance. They seamlessly blend with the car's aesthetics, as if they were born to be there. It's like having an invisible shield, protecting my ride without compromising its sleek appearance. Talk about style and substance! Durability is another area where these guards excel. Despite facing rain, sun, and even the occasional bird droppings (yes, I've had my fair share), they remain firmly in place, ensuring year-round protection for my beloved vehicle. No peeling, no fading—just reliable defense day in and day out. So, fellow car lovers, if you value your four-wheeled companion as much as I do, don't hesitate to invest in these clear defenders. They'll save you from those heart-stopping moments and keep your car looking sharp. Trust me, you won't regret it! In a world full of uncertain door swings, let the Car Door Edge Guards be your trusty sidekicks—protecting and preserving your ride, one door ding at a time.

I ordered the clear model & read a lot of the reviews about how to apply this product. With that in mind, I used a degreasing product on the edge of each door & wiped them down following with a clean rag to remove any road film left in the crack. There is a ridge on each door that the adhesive side of the molding fits. I started where the ridge on the inside of the door began & pulled 4-6” of the red tape off & pressed the molding onto the edge with the adhesive side against the ridge till I found a stopping point. I used a rubber mallet to gently tap the molding against the doors edge. Update: tip to make installation just a little bit easier, unroll the hand coil of edge protector, let sun warm up protector & unravel twists in protector b/4 you try to install it. It makes applying the protector a little easier if you take the twists out!

Okay, so this does not look at all how it looks in the pictures. It isn't that nice fresh looking transparent edge. There is a medium/dark gray adhesive strip inside the length of the product, plus the product isn't coiled nicely, so it doesn't sit straight on anything as it's so kinked. Inside edge looks like plumbers putty, and unevenly applied putty at that, and the outside sits in a wibbly line as the package is loosely coiled cheap product that takes on this form. It also breaks and squashes the adhesive and red plastic removal strip, so the whole job doesn't sit nicely, looks cheap, and the plastic line covering the adhesive meanders up and down, so in places gets trapped while removing. Returning this as it's blatant false advertising. Still looking.

The car door guard door is a good product. My husband used it on my car and found it easy to cut and install. It seems to be working well and looks fine. The strip is clear, durable, not too thick where it will look bulky. Good product.

Does what it says and easy to fit

Es útil para evitar pegar a los bordes de las puertas, compré otro pero es plano, no acanalado como éste.

Normal protectors have metal edges which scratch the car door this doesn’t have any such edge, hence paint remains protected I do wish the overall size of the product was a bit broader as it’s quite narrow and doesn’t stick very well ( it could also be becuause of the monsoons) but it has come off twice and I’ve had to reapply it the plastic however is of very good quality

fast shipping, product as described. very happy. thankyou

It’s ok but it’s not very wide and just fits on the door trim would have been better if was wider