20 Pair 30AMP Quick Disconnect Power Terminals Connectors, Red Black Quick Connect Battery Connector Modular Power Connectors Set…

A bit tight to insert but once inserted they are solid I used 14 gage stranded wire and soldered same

1. They connect fine with my Anderson and other non Anderson connectors. 2. They slide together nice with no biting. As good as Anderson and definitely better than others. 3. I had no problem using the proper gauge wire with each connector. No melting as I use the correct wire size and length needed properly address the amperage/current. Seriously, the proper length and size wire cannot be overstated. Use the online calculator at Wirebarn and remember the length is shows in the calculator is one way (one wire), as the ground would typically be at the chassis near the component. If you are going to run both positive and negative wires the same length, you need to take that into account and divide by two.

Fine for non-critical systems / bench wiring. Definitely not 100% the same as genuine powerpoles, and wouldn't necessarily expect them to interoperate perfectly. That being said, they're wonderfully cheap and I'll gladly continue using them.

Probably the least expensive powerpoles i have purchased in my days. So far I have only needed to give one of the connectors a minor bend so it will fit. The box is obviously made for something besides this but it works. I am satisfied. You're going to be bending the connectors to crimp to the wire anyway so if it doesn't click, troubleshoot. If I were unplugging and replugging them in often, you may go with a better set from HRO (the new AES if you're an older ham) So, all in all, this is a buy if you're just going to plug them in and only use them when you are moving your radios or whatever you are using them for. I wish that there were more than one set of colors on amazon but I digress. (I like to differentiate between lines that are switched by the ignition in my truck or low amperage lines etc but I guess I'll just pull out the label maker)

I've tried a few different brand/makes of power pole clones on Amazon and these are the first advertised as "30amp" that actually have terminals that accept the 12ga wire needed for 12v 30amp power.

Appears to be a very good quality

Perfect on specified GA. wires works best in combo with heat shrink at wire ends to. Even Useable with standard crimp ratching pliers also with smaller wires ability to solder in . These kits do not have an extraction hook tool something that should be with all power pole kits. Bottom line Works.

Works well for their intended purpose.