AR-PRO (8 Pack) Hard-to-Find Spring Steel Push-On Pushnuts - Dolly Wheel Lock Washers Fits 5/8" Dolly Axle Rods with Oiled Phosphate Finish

These are not easy to install so be careful. I can't believe how much they cost for so few. I mean there is less than a pennies worth of materials to make these. I have been at it for over a week trying to get in on the tire for the dolly. I am leaving it to my son. BUT it has to be like that, others have used the parts that came with the replacement tires and said it went on easy but the tire is always falling off and they finally had to by this type of replacement to get it to stay on. The one side went on really easy and stayed on, but the other side is being very stubborn. I took the advise of a woman on youtube who said use a block of wood. No that didn't work. I finally read the instructions that came with the tire and said to use an old socket to provide equal pressure all the way around when tamping the pushnut. Going to give it a try. But sincce the other tire is operating quite satisfactory, without any losening or slipping I say they work well. I will have to buy another set to add to storage.

they were a little lighter duty than I would have preferred and there was not thickness detail on the listing of these washers, so it was hard for me to assess. i would have preferred twice as thick. They worked.

The item fit perfect. My dolly truck lost the washer that held the tire on the dolly. I went to ace hardware and Lowe’s and they only had one that went up to 1/2inch. Most dolly trucks are 3/4. So happy I found this seller

These are not the cheap flimsy push nuts like many have described. Now , they are not as thick as the original ones I removed from my hand truck, but after removing the old rims and tires, sanding and preparing the axles to accept the new rims and tires, these push nuts installed with ease. They are of good quality and have been holding up just fine on our commercially used hand truck. No complaints at all.

Perfect for the hand truck I bought for cheap and fixed up with new wheels! I bought the 5/8in version and they worked great, just make sure to measure your wheel axle diameter Pro Tip: use a deep socket and a rubber mallet to tap these on evenly, for the 5/8in version I bought, you could use a 3/4 or 13/16 deep socket

Just what I needed

Exactly what I wanted

Perfect fit push nuts for holding on old hand truck tires.