Coopache Ethernet Cable Clips Adhesive, 3m Wire Clips Holder, Self Adhesive Wire Clips Management for Home and Office (100 Pieces)

The clips are a bit tight so it takes a little effort to get the cable seated inside. Could also use more adhesive but overall good value for the money. Would buy again.

These were put up going from my kitchen to my living room and then from the living room into my son's room, placing them about every foot. I ended up using all but two from the package, so one package goes a long way. These will not stick to any crown molding but they did stick to the side of the door frames. While I wanted to hide everything onto the crown molding, I couldn't so I placed it just under and the stuck to the latex paint without an issue. They did rip paint off when I misplaced, so keep that in mind. It is difficult to get the cord in because of the way they clamp, so put on several at once and work your way through them down the line. You definitely don't want to be putting them on individually as you go. You will end up loosening the ones already placed. Once on, they are very difficult to get off and once on the wall, the clamp is not going anywhere and it is not opening. All of which is good. If we ever have to string more ethernet cable, I will be reordering these.

Just remember to clean the surface you are sticking it to. That tape holds well unless there is any dust, finger oils... Once I figured out why it wasn't sticking (just some dust) a quick wipe an vola it stuck. It was also easier to put the clips on the cable, then peel them off a few at a time and stick them with the cable inside already.

Looks sturdy enough to hold my telephone and LAN cable

This product is fantastic if you only have to lay your ethernet cable in a straight line if you need to turn any 90° Corners get something more substantial like something that uses a nail because the adhesive isn't strong enough to hold in that kind of Bend but overall still really good and very low profile hardly notice the cable is there. I personally use this one for all my straight line runs and then add one of the ones that uses a nail for the bends and it works perfectly