VBSI3214PR Window, 32" x 14", White

I wish I could give this 10 stars.. I searched and searched for weeks to find a window this size that was good quality. This not only looks great but also got outstanding reviews from my contractor! It’s solid, easily installed, and looks amazing. It’s worth every single penny and more. I’m so happy with this window!!!

Good price

Our windows in our basement were in desperate need of replacing. Our house is not new and our basement is just concrete walls/floor. The old windows were the aluminum frame style. I was able to leave the metal frame surrounding the concrete opening, all I had to do was remove the plastic spacers underneath the screws in the new windows. I put them in, pre-drilled the holes for the screws and screwed them in with concrete anchor screws. Then I used door/window expanding foam to fill the gaps and afterwards, I sealed the windows with window caulk/sealant. These windows do a great job of keeping out the cold/heat. They open, close, and lock with ease. They look great and we have two more windows in the basement we will be replacing with this same style. I recommend the following tools if you have a similar job to mine: 1/4" Concrete Anchor Screws 2 inches long, Door/Window expanding foam (the white stuff at Home Depot is best), Door/Window Sealant/caulk, and hammer drill, masonry drill bits, a good contractor's break-away knife/razor, and a razor blade for cleaning up anything that gets on the glass. The windows did not take much time to install.

This is really a very fine window. It was wrapped and packaged very securely. However, the window did have one corner of the fin broken off; it appears it was packaged in that condition, though...did not happen during shipping. It was not a significant material damage,and we were able to install the window after making the repair to the fin. The window installs like a replacement window rather than nails through the fins in a new construction type window install. The fin is simply a stop to hold the window at the right depth position against the framing. Attaching screws are installed from the 2 sides from inside.The only other issue is that their is no handle or grab plate for opening and shutting the window. That would be nice as it is not good to push and pull on the locking mechanism. I had to reinforce this fact on members of the household using the window in the shower we installed it in.

Worked perfect for my daughters room. We had turned part of our basement into a room for her and it need an extra window. this is the perfect size. Was easy to install as well

My daughter installed our Basement Windows.We are very satisfied and happy!

Great basement window. Replaced the old awning style steel framed/1/4" thk glass windows that were embedded into the concrete from 1950s. I needed to chisel/pry old frame out but wasn't that bad. These windows are excellent for the price and are efficient if installed properly. Be sure to use spray foam specifically for windows and doors due to expansion rate. You do not want to use a high expanding spray foam. Throughly caulk inside and outside joint and you'll be happy. I needed a hammer drill for my application along with plenty of plastic shims for leveling. It's been over 2 years, four installed with mid 90s in summer/ low teens in winter and has been great no leaks 👍. Weep slots always go at the bottom of the sill**Updated with 4in dryer exhaust vent retrofit. I removed the slider and set aside as spare. Used prefinished white 1/16 alum sheet (azm/HD) with #7x1/2" hwh screws. Careful not to puncture anything beside the rpvc frame. Did this outside and inside and sandwiched tightly fit insulation board in cavity between both alum sheets. Be sure to use plenty of silicone around the dryer vent components, the perimeter of the alum sheet to frame and all fastener heads. At the very end of installation I applied privacy film as these are on ground level. Still let's in great light.2024 update: it's been 4yrs having these windows and everything has been great and performing as expected. No breach in the perimeter glazing seals (no condensation, fogging, streaking etc.)Solid product and well made!

this is for my garden shed, and we are very happy with the quality. Nice slider