10EP5122K20 2.2k Ohm Resistors, 1/2 W, 5% (Pack of 10)

Got these to fix the dreaded Chevy intermittent no start on models using the Passlock etc. security system. Its been well over a year and no further problem.

Solid resistors - work great!

I used this resistor to bypass an oxygen sensor on one of our automobiles, following a performance modification. It works perfectly. No more check engine light and the engine runs correctly now. The leads tin up well, using ordinary electrical solder, and the value markings are clear and permanent. Good purchase...

Worked Great

no problem

Was recommended to use this when doing the catless up pipe upgrade in my 2002 Wrx. In theory it should keep the check engine light away since you are removing a whole sensor in the exhaust. So far I’d say it works, I have not seen any check engine lights, car runs perfect, no limp mode or anything. Driven the car about 200+ miles with the resistor mod so far. Used a rubber glove thumb to cover the open wiring where the original sensor was unplugged. Though I have not tried it without the resistor mod. So, I wouldn’t know if there is or is not a check engine light that comes up. There’s been some debates on old forums if it does or not so, I’m not sure. But I played it safe and grabbed these.

As advertised

Ok

What I ordered! Older Nissan vehicles used a resistor for voltage control of the distributor coil. It starts at 12 volts, and then the ECM drops to 9 volts to keep the coil from overloading. And thank you Amazon for how fast I got this!

Met my requirements

It Work for my project

Ordered to stop hood latch alarm on a Silverado. Worked perfectly

Bonne qualité du produit et tres bon service