Spectre Performance 771 Low Profile Dual Plenum Kit with 45°/90° Tube, Silver,24.3 Inch

Worked out great for the application

Fits perfect and works great.

Good quality product. Should come with mounting nut/stud for the price. Great product, but overpriced for not being polished or cleaned up and no filters included. Might need to order/make a gasket for carb mounting point. Doesn't seal 100% air tight. But honestly would buy again.

If you are looking for a great looking low profile plenum, this is the one. I had only inches to spare from my carburetor and hood, and this came in on the mark. I also had limited room to run the tubes to the side and forward as well. Used the Spectre 4213 Stud Kit, the Spectre 4208 Air Cleaner Nut, and the Spectre Performance 8161 Black Air Filters. Cut the Stud to the appropriate size, lose the wing nut it comes with, 4208 to top it off, and then install the filters. It looks very clean. Make sure to verify distance from the top of the carburetor to the bottom of the hood. Even subtract 1/8 to be safe. Also make sure to verify the width you need, downward angle, and forward distance you have available. You might find simple hoses, cable, and brackets in the way that you did not suspect. Contact the Seller if you have questions especially if you are not running a stock engine.

It does fit in low profile situations I will give them that. But the finish of these “polished” pieces is a joke, especially for the ridiculous price they run. The finish looks like pure knockoff quality. I’m having to end up having them powder coated to look semi decent. If you only have a couple inches clearance it’s a good option as long as you don’t care about or have a plan to correct the finish appearance. Oh and it doesn’t come with the gasket for the carb or filters so you’ll have to buy those as well

The media could not be loaded.  Terrible finish

Was a good starting point…. Mission’s accomplished…. No holes in my corvettes hood…….

it fits

Would not fit and product was scratched up when I recived it.

This was clearly a return from someone else who scratched the hell out of the chrome and aluminum. Also the aluminum is not polished and does not match the chrome at all. They are sending me a new one, so we'll see if it's any better.

I thought the quality of the casting was poor lots of pits looks good from far, closeup not so good