JUXINICE CAT6 Shielded Ethernet Patch Cable 90 Degree Right Angle rightward,FTP RJ45 Gigabit Network Cord,Cat 6 High Speed Computer ethernet Cable -10Feet

This works well in tight places where a desk is up against the wall plate. This will get used a lot.

Note that this is not one of those slim and easy to bend cat6a cables. This one is pretty thick with larger jacks. Otherwise it's a nice product and seems to work well.

I like this cable because it has a low profile and doesn't stick out of the wall by very much.

So, these are CAT 6 network cables. They work great, but with cables a lot of times they either work or they don't so it's hard to say what the quality is there beyond, yes, they work. I will add that the outer covering seems to be high quality, being sturdy and strong, as well as flexible enough to run in and around everything. The plugs lock in with a satisfying CLICK and the right angle means that I can use the network plugs behind my bookshelf without having to have the bookshelf sit a mile away from the wall.

Seem to be good design, quality control lacking. Locking tab very flimsy. Fortunately I ordered 2 and they will be behind a wall shouldnt be disconnected multiple times,

the cable is strong and durable and works in the 3d printed enclosure that i made for a steam deck.

A right angle Ethernet cable is needed to allow for devices in tight places to be connected. This specific cable, including its connector, is very thick and bulky. In my specific use case, this size results in my device being lifted off the table on one side, since the cable is thicker than the device it’s plugged into.

It helped me a lot to connect my network from wall while there is a big shelf in front of it.My previous regular network was broken when I pushed shelf too closer to wall.

The only issue I had was that the ends would not clip into the ports and lock in. Both sides easily slid in and out.

PERFECT,,,,Thanx

The retainer clips are very brittle. One cable was DOA. Bad pair.Not impressed

Cable somehow only provides around 90mbps vs the 260+ that I pay for thru xfinity. The cable I was using previously provides near the rated speed. Look elsewhere for a cable if you want to use the full capacity you're paying for.

So I got this in the mail today to replace a 50ft that was not needed and it is not a cat 6. This was a rip off. My normal speeds are 900+ upload and down load and after tech support for my internet came out. They spend 3 hours trying to figure it out. Come to find out it was this cord. So they tested it and I tested it. My speeds were less then 100 up and down load. And there test proved it was just a normal either net cable. I will be returning and will not buy from this vendor again

Cables won’t secure into the slot. Waste of money.

I wanted a 90 deg fitting which this design is exactly what I wanted but the data transfer is very limited. I have 1Gbps fiber and could not even achieve 100Mbps. Even transferring files on my network server was extremely slow. I don’t have a tester to see if the cable is damaged causing the issue but this cable is the cause of slow transfer after trying several different cables this was the only faulty. The cable is a heavier gage than any other LAN cable I’ve used.