CSFMCFurniture Leveler PTFE(Teflon) Bottom(28mm Base 1/4-20,8 Pack),Threaded Shank Adjust Pads,Table/Chair/Cabinet/Sofa Medium Adjustable Legs Leveling,Nuts Installation and Floor Protection

Q: Need to use outside in farmers market. Is this stainless steel or plated?

It is steel with an anti Rust coating. It is NOT Stainless Steel. I would guess for the money the coating would work outside for a long time unless you will be setting up in the snow/salty conditions?

Q: I am using the feet leveler for a shelving unit. What is the load rating of your item?

I am just a guy that uses this type of leveler, not a representative for the company, sorry. I don't know that answer but I would think it would depend on the material you are installing the levers into and how high you want to have the levelers extended. I have built bedside tables, end tables and coffee tables for my kids and grand kids and the farther out you extend the leveler, the more wobbly it will be no matter the weight rating. If you have the levelers extended 1/4", it will be able to support much more weight than fully extended. I trust my common sense more than an engineer's rating because of the variables of material and length extended personally. No offense to engineers!

Q: @Michael Thanks for your response. I meant the diameter of the threaded shank that inserts into the leg and into which you screw the leveler bolt?

I don't have a micrometer to exactly measure that anymore. I will guess you are trying to figure out what size hole to drill for installing the levelers? I have seen charts online with what hole size should you drill. It is dependent on the material you would be drilling into. a soft wood would use a slightly smaller hole than a hardwood. I don't remember what I used off hand. If you purchased levelers with the insert nuts, you will need to drill the hole slightly smaller than the insert size, not the stem size, just deep enough to fit the insert nut. I hope I answered it this time. Sorry for not getting it last time.

Q: What is “drunken furniture”? How do you wipe “clean with concrete”?

Drunken would refer to unstable or wobbly furniture. I suppose it was supposed to say wipe the concrete so that there is no debris under the feet.

4.5/5

معرّف المنتج: 396608303

معاملة آمنة

يُشترى معًا بشكل متكرر

الوصف

CSFMCFurniture Leveler PTFE(Teflon) Bottom(28mm Base 1/4-20,8 Pack),Threaded Shank Adjust Pads,Table/Chair/Cabinet/Sofa Medium Adjustable Legs Leveling,Nuts Installation and Floor Protection