Flutesan 20 Pcs 3 Pin 10mm Solderless LED Light Strip Connectors Clear Track Lighting Connectors for 5050 RGB Strip Light

Very easy to use and effective

I needed to solder 30 LED segments together for a project, which I was not looking forward to. These turned out to be a great alternative. There are wire guides that fit 22 guage wire perfectly (without stripping) and hold everything in place. On the other side are pins that pop through the copper LED pads to great a secure connection while preventing the LED from moving. If you make a mistake, these are easy to open, too. I just wish they were a little smaller (a need for my project) and more came in a pack. I have had to buy 3 packs. All in all, these should hold up as long as solder would with no fumes and no costly mistakes (like removal of copper pads, which can happen when soldering LEDs)

Worked pretty good. Not sure how strong they are if you have weight or pressure on them. But, they worked how I hoped they would.

it's easy to push the copper lands of the light-strip past the "teeth" of the connector. no biggy. Just be careful. However, the images include a photo of the connector being used to connect wiring to the light strip. and this may be theoretically possible but practically impossible. There is nothing to keep the wiring aligned with the pins as you close the gates. And you have to keep three wires aligned. Good luck. This purchase was to make connections more reliable for high-school students that need to do this frequently. Soldering is still easier and better.

It's been said that the product doesn't fit in aluminum channel. This product fit my aluminum v channel. Rather tight. But, I was still able to get the diffuser on with no issues. So Super Easy to install. I have used 4 out of 20. All 4 worked flawlessly. Didn't scap a single one. UPDATE: used 10 of 20. Works as intended. No issues.

Worked great! I ordered these for a 3D project I printed on my K2 Plus.

I have not used these adapters for long, but they have so far exceeded expectations both in ease of installation and strength against tugging and pulling. Installation was easy using 22awg silicone STRAND wire. I think it won’t work as well with solid core. Easier to use a lower pixel/meter strip, they give you more room on the copper pads. Regardless, you will need to aim the strip precisely on the adapter to make sure their is connection with adapter spike and copper pad. Leave wire unstripped, the adapter spike will punch through the wire coating and hopefully imbed itself in the coiled wire. The adapter also uses the wire coating to hold the wire in, so be sure the coating isn’t too hard.

I used these for an LED project where I was making multiple shorter sections. These worked well, as expected. The wire holes were too small for the original wire I was trying to use so I went with a smaller gauge wire which is working fine.