Adjustable Round Nozzle Coolant Pipe with Magnetic Base

Great price and value. Use this daily for my Lapidary equipment. I like the magnetic base and the ability to position my water in the precise location for the work I am doing.

Used for air assist setup on a fiber laser. Works great and the powerful magnet stays where you put it. Very flexible hose that works well for precise aiming. Highly recommended.

Overall, pretty good. I could not get the plastic fitting to seal, nomatter how much Teflon tape I put on it. (Monus 1 star) However, I'm using it for wetting stone polishing, so it's in a wet environment anyway. Given the low price, no complaints. The magnet is very strong. The valve is easy to adjust. The outlet position is infinitely adjustable, and hold its position. The brass fitting on the inlet side should hold up well. It's nice that the kit comes with a hose clamp. I used a camelback style bladder as a gravity fed water supply.

Perfect for a drip system on a grinding disk where control of the flow and placement are important

1/8" hole on the side wasn't tapped deep enough to accept 1/8" npt fittings. It was shipped with a 1/8" nps thread barbed fitting which I can not seem to find anyplace. The plastic threads on the nozzle were so bad that you couldn't tighten it, it would just spin. This setup might work if you don't need to change barb size and the fluid is gravity feed. As shipped it won't hold any pressure.

Love the magnetic base. Works really well.

Muy buena calidad, imanes muy potentes

The magnet is too weak for the intended job. the Flexible line-loc copy is non standard and smaller, thus less flow and more pressure loss.

es lo que esperaba