Guide Rail Adapter Compatible with Milwaukee Router - Made in USA

Affordable and an amazing tool. I used it on my Milwaukee router on the track saw and the results were dead on and completely accurate without any tear outs.

Overall excellent product. Fit both my Milwaukee trim router and Milwaukee track saw track perfectly and allowed me to route absolutely straight channels for t-track. No wobble or play at all. Great tool!

The fit to the router plate was spot on. I have the MIlwaukee palm router and Milwaukee Tracksaw track.Like other reviewers pointed out the centerline triangle on both front and back are off by ~1/8th of an inch to the left of the Milwaukee palm router centerline marks on the router base that can be used instead.The fit into the rail does have a slight amount of play, but can be overcome by keeping pressure to one side while routing.

I bought the router and bits as well, and they all work so great together. Makes my job ten times easier and the guide saves me so much time! I have noticed a lot less mistakes on the wood working and touch ups that I have been doing. Would definitely purchase again.

I did not use it with the advertised circular saw tracks but used a Milescraft saw track instead. It wasn't a good fit but I glued the Milwaukee router mount to the provided stop piece which fit perfectly on the Milescraft tracks. So I managed to create a router guide with the Milescraft saw track by using the Toolcurve router mount glued to the Toolcurve stop piece which attaches to the Milescraft saw track.

Have been making dado’s using the table saw, router table or a self-made jig on long boards. Normally they come out fine but sometimes not so fine. When I saw this jig, I was at first apprehensive because it seemed so simple and inexpensive. Decided I didn’t have much to lose other than a few bucks so gave it a go. Wow, I was blown away with the results. Should have had this years ago. Now I am considering getting the jig for the plunge unit on my Milwaukee M18 router.

The media could not be loaded. I really wanted to like these. I've attached a video clip for the stop, but amazon only allows one video clip per review, so just gonna have to take my word on the router base. so on to my review...first with the router base...it is super tight in a festool track, almost jerky, which doesn't work with routing where you need smooth motion or you're bound to ruin your work piece or lose a finger. Next, the stop. as you can see in the video, even when fully tightened, it slides easily...kinda defeats the purpose of a 'stop'. if only the router base slid like the stop did, and stop was as tight as the router base....then they would be usable products

Just another great product by Milwaukee. Powerful motor, instant stop, great feel, easy to clean, 6 speeds. Just all round great router. Can’t go wrong with these guys.