Dremel TR563 Laminate/Sheet Metal Bit, Carbide

replacement for the cutting bit that comes with a dremel Trio. I was using this to cut some cabinets up and it broke, havent been able to find one @ any local stores... Ordered this and it fit perfectly into the Trio which has a bigger chuck size than the other Dremels.

As with all Dremel tools and accessories they are expensive in relation to others. But you get what you pay for and this bit is a good bit for the job intended. Happy with listing and performance of bit.

Good case, because it's slim it fits well in the pocket, it's not bullet proof but I've dropped it a couple of times and if the case wasn't on the iphone, I'd would have to get a new phone.

So. Pre drilled a hole in my sheet metal, although this bit and directions state this bit is perfectly capable of drilling the hole, then cutting. I watched dremels demonstration using this bit, the dremel trio, and cutting sheet metal ductwork. It looked like it was cuttin thru margerine with a cold knife. No problem. So I load up my TR563 on the Trio and press the power button. 3 seconds and .5mm of cutting the bit just snapped. Project is on hold. So far Unimpressed.

I tried to cut some thin sheet metal for a car repair and the bit broke quickly. It is probably OK for thin laminate or plastic (cut through those like butter!) but I would not recommend this for metal....even thin metal like I tried to cut. Have not found many uses for my dremel trio tool overall (got it on sale for about $12) and wanted to try it out using this bit. I will possibly try it again on some car interior trim pieces inside of the car, might have betterluck using it there. Perhaps I am not using the tool correctly. I was hoping that these bits would give me an excuse to use the tool more, but was disappointed that this was not the answer.

Broke a bit went to Lowes and they wanted $20 a similar item. This was a Carbide tip and was 1/2 the price.The items were as advertised and were expedited quickly. A+ transaction all around.

Bought it to cut into floor tile and it worked. But when I used it on metal it broke. I got one use out of it for $20

Love my Dremel and all it's parts. The bit does it's job! D.M.