SUPALAND Key Fob Replacement Fits for Cadillac SRX 2010 2011 2012 2013 2014 2015 ATS XTS 2013-2014 ELR Push Start Button Smart Proximity Keyless Entry Remote Control NBG009768T 22865375 5 BTN

Worked great , easy to program. The fob is a perfect copy of the OEM so I was able to swap the original Cadillac embossed cover from the old fob for the generic one that comes in the package.

So I needed an extra key Fob for my 2013 ATS. The old one was getting old and not working properly all the time. I was getting an error message on the car that said “remote not detected”. So I knew I needed to get a new key FOB soon. I called the dealer and they told me $225 for the key fob and $225 to program it. So $450 total. So thought I would take a chance in this and program myself. So if you look in the 2013 Cadillac ats owners manual it does have instructions. I followed the instructions and this key fob was programmed and working in less than 10 minutes. I have use this for a couple months now and still works good. I don’t get the message “remote not detected” anymore. I would definitely buy this remote again instead of going to the dealer.

This FOB programed using below instructions. Door open and closed buttons have trouble, but a few tries work. The 3 remaining buttons work well. Better fobs are available. However, for 25 and next day delivery I was very happy to have back up Key. NOTE: YOU need a working FOB to program with car KEY PROGRAMMING INSTRUCTIONS —roll down window —place working fob in cup holder closest to center console —place new fob in key pocket with buttons facing in —place key into door and turn five times in five seconds —press start without the brake, then wait 30 seconds (time it) —check new fob by locking/unlocking door —if this works, press and hold start for ten seconds (time it) —replace new fob to key pocket. Leave old fob in cup holder, leave key in door —set timer for 15 minutes…after 15 minutes the new fob should work

Came in broken missing a button. With the car in programming mode it would not recognize the new fob. I place an old fob in the slot and it recognizes it right away.

I needed a new fob for my 2104 SRX because my old one gave up its ghost. So, I was looking to keep my emergency key and not go through the trouble of making a new one. Unfortunately, the old key doesn't quite fit in this fob. The end alignment pin on the key is larger than the slot on the case. Oh, so close. I could probably take a small file and enlarge slot but my solution was to put the circuit board from the new fob into my old case. THAT FIT PERFECTLY. Go figure. The savings over buying the GM replacement more than offset that issue. Also, the programming instructions stop short of telling you how to assign a driver seat memory position to the new fob. That seems like a critical flaw when you're used to the seat adjusting as soon as you open the door. If you're going to rely on 3rd parties to provide this information, you might select a source that has all of the required information.

Works better than my original

I should have ordered two it’s the same one ready to be programmed.

I was not about to play GM 300 for a new fob reprogram just because my fob was dirty and wore out so, i transferred the guts of my OEM fob to this one The key fit fine getting the board in was easy enough to line up color is close enough original emblem fit where it should. seems to be a bit more durable then the OEM, Looks close enough no one would be the wiser.

No funciono ni con batería