SWDPDT10A - On Off On Toggle Switch, Latch Action Pre-Wired DPDT, Reverse Polarity Switch for Forward Reverse Functions

Appears to be of good quality, it's beefy enough. Functions as expected, I added it to a ventilation fan in my motor coach, the existing had 3 speeds a thermostat and auto opening, but not reversing, we like to have outside fresh air whenever the outside temperature is agreeable.

The switch I ordered came all wired with spade terminals all I had to do was switch a couple wires and done less than 5 min.it took longer to drill hole than wire this switch.....

The Makermotor forward/reverse toggle switch comes fully wired at the same or lower costs than more similar toggles alone. Plenty of wire length to work with unless your motor is a really long way from your control switch. Good for up to 10 amps and good bang for your buck.

What can i say its a quality switch with some wires already attached to allow reversing of a small DC motor. Not much to go wrong with this purchase.

This switch is being used along with the Makermotor 3/8 D shaft motor to rotate the discharge chute on a 6-foot tractor mounted snow blower. The switch works well for rotating the chute cw and ccw but it does leak voltage to ground when in the off position which caused the battery to discharge. We had to wire it to the ignition switch in the run position to eliminate this problem. Also, a momentary dpdt switch would be better for this application. We were pleased to get the switch prewired as well.