Mega 2560 R3 Prototype Screw Terminal Block Shield Board Pre-soldered Kit, Breakout Module for Arduino UNO

Cures jumper pins the become loose. No more tracing connection problems.

Cheap pins that came bent all different ways, was worried that pins would break so I was very careful in bending them. Tedious and time consuming.The board is too narrow and that causes the terminal block screws to be unaccessible once the main board is installed.

I read that this is a problem from other reviewers before purchase. Yep. It is a problem. About 15 minutes of work with pliers and gently inserting the pins in a MEGA2560's female pins a row at a time, and I successfully mated the board to the MEGA2560. It meets the training need that I have for the board, is priced okay, but is very poorly packaged for shipment.

It works like it should, but like others my pins were bent when I got it, all I think they would have to do is put another or thicker piece of the foam stuff over the pins

very poor packageing resulting in bent header pins.I was able to straighten the pins to make it useable.other than that this product worked as expected.I would not recomend purchaseing from this particular vendordue to packageing.

All the pins were bent on arrival. Arrived in a zip loc style baggie. No box

Bought two of these because my brand-of-choice was out-of-stock. Overall they look fine, but, 1 of them came without the pins inserted into foam and thus a few pins were bent (one quite a bit), but I was able to carefully straighten them. The other board came with pins inserted into foam, yet, 1 of the pins was still slightly bent. They might be functionally 'good' boards, but, their packaging/handling could be better.

Several of the terminals were not soldered correctly. There was no continuity on a few pins; the arduino pins to screw terminals had no continuity measured with a meter and tested as well.