araree Aero Flex Galaxy Z Fold Series Case with Hinge Protection, Protective Slim Cover Protective Body (PC) with Hinge Protector (TPU), Compatible with Galaxy Z Fold 5G - (Green, Galaxy Z Fold 4)

I had originally purchase a Spigen Tough Armor for this phone. Shame on me for trusting Spigen a 3rd time around, as I had used them on 2 separate occasions with the Galaxy Fold 2, both of which broke with the smallest of impacts. One thing that sucks about the fold phones is that it is hard to find a case that won't make the phone any bulkier, but I really wanted a case that would protect the spine of the phone, all the way not having something that would stick out behind (for wireless charging purposes). So I tried the Spigen Tough Armor again for the Fold 4, only for it to break the moment I set the phone down on my desk a little too hard (legit the phone fell out of my hand and dropped no more than 6 inches onto the table top.I sent the case back and began my search. I found this case and well..here I am to give you some key points that I have found to be awesome:- It does not require any glues or adhesives for the case to say in place. If your case is shifting around on the phone, you may need to reapply it or should probably exchange the case for a different one.- Because the spine protector doesnt go into the case, but rather shifts behind the phone, the case itself is actually less bulky than the Spigen Tough Armor.- I've dropped the phone a number of times now. One time, I accidentally dropped it from about 3 ft to the ground, and the case took the hit. However, despite some scratches, the case is still intact and working very well.- It is obvious that the construction of the case is MUCH stronger than Spigen's cases.All in all, the Araree case is awesome! Just a quick tip. If you are having issues with fingerprint reading, I suggest redoing the fingerprints with the case on. I noticed the same thing and maybe this is caused because of the phone case is really close around the fingerprint scanner/power button, but once I reset my fingerprints, the scanning worked out just fine every time after the fact. I found that fingerprint scanning was not affected after doing these steps, with or without the case on the phone.

I think that The overall case design is a good concept however the execution of the design is very poor. The case doesn't hug the phone very snug or tightly and leaves a bit of wiggle room between the phone and the case. There's no adhesives to secure it even better to counteract this issue. And the rubber that is covering the phones edge or it's hinge isn't that great or supportive. In fact it's quite flimsy. I had this phone case for a week and had to switch it out because of my doubts in it's ability to protect my phone And it's overall discomfort It causes when handling the device.

The media could not be loaded. It feels nice to hold as well as the hinge being nice and flush with the phone unlike other company’s. Others useful stick out and make the phone much bulkier which this case does not. The case folds nice and the hinge is smooth and has a nice feel as well. Probably the best thing about this one that the other company’s don’t think about is the front screen cover gestures this case has good cutout for a screen protector as well as good edge protection while having useable gestures other make the lip to thick. Case has good camera lip protection as well great case the best I have tried so far out of Samsung ghost tech and more.Minor things is I wish it had MagSafe but i couldn’t find a good case with MagSafe. I wish it protected the corner of the hinge a little bit more but other then that it’s great.

Gone through a lot of different cases for this phone, and this one is by far the best. Covers the hinge nicely without making it really bulky, and just feels really good in hand. As others have mentioned, fingerprint scanner is a little hard to get to, but not impossible. And the depth of the outer screen protector makes using the edges of the phone a little difficult. But that being said, more than a fair trade. Had to super glue a little piece of the strip that holds the little screen protector to the big screen protector, but I'm going to keep it and still give it a high rating just because it is such a solid case.

Honestly I didn't expect much but case came pretty clutch for the price. Had it on couple days now and compared to alot of other cases I've had this is good stuff for the price. Seen many over 80$ and this is just great for under 25 bucks. I use a tempered glass in front and fits perfect. Not sure how long it will last but it's great for the price point. Had other cases with hinge protection but they all are magnets and honestly make it bulkier but this one isn't too bad it actually lays flat. Typical hard plastic for a case and seems to be on there solid. I've had 4 other cases and so far this the one I enjoy the most. Time will tell on degrading but I'm happy for now, only con I have is that the hinge part is not tight when closed, has like a little roundness to it so it leaves small gap on top and bottom of the hinge but it's not crazy like the otterbox ones. For the price and quality you can't go wrong since only the spigen and otterbox offers this style and costs 80+$

I purchased the case in December 2023, and by July 2024, it was useless. Within 30 days, the connecting middle portion snapped and disengaged. I used superglue to keep it operable until that no longer worked.I also found that the case did not tightly hug the phone when opening. May I just have gotten a bad cover from the batch? Nonetheless, I would not purchase another.

It's a very creative case, and I like how it holds in the hand, but my three gripes are the front protector is a bit high, so it makes it hard to swipe home. The next issue I have is with the fingerprint cut out. If closed, it's a little high and a little hard to get into the scanner. A larger cut out, or a cut out on the opposite side would fix this. Lastly, the corners of the hinge are not fully covered, to were a fall at a certain angle could do some damage. 3 stars for design. Feels sturdy, and has a very nice way of keeping both sides of the case on.

Five stars...stylish, durable and really good protection for phone on all sides (top, botton, hinge). It's not a slim case, but also not bulky - this case strikes the perfect balanace.

The sleek design and hinge protection!Can't go wrong with this purchase

カバーディスプレイ側の枠はすぐ外れちゃうし、ヒンジもうまくフィットしない、おすすめしない

開いて使う分にはとてもいいケースですが閉じた状態では厚みがありすぎて押しにくい画面を守ると言う面ではいいと思います

spigenの全面保護ケースを使っていたのですが、４８ｇとこの製品より１５ｇほど重く、ケースのエッジが角ばっているので手が痛かったのですが、arareeの全面保護ケースは３３ｇと比較的軽く、エッジが丸みを帯びているので持ちやすいです！とにかく持ちやすさは最高です。でも、カバー画面の側面を覆う部分の縁がかなりもりあがっているので、画面横からのスワイプがやりづらいなりましたが、設定次第で問題は回避できました。あと、指紋センサー付きの電源ボタンのところは開いていますが、空いている部分が小さいため指紋センサーに指が触れる面積が小さくなりましたが、ちょっとでも触れれば認識してくれるので全く問題ありませんでした。スワイプがすこしやりづらいですが、持ちやすさ軽さが素晴らしいです。