Phrozen ACF Film Mega 3PCS (290 * 450 mm)

This stuff is great!! The negative reviews relating to “tears”, “leaks” and protective film removal are user errors. I know because I learned the hard way. The product has to be oriented correctly. There’s a shiny, slick side and a coarse side. The coarse side has to be on the bottom facing the light. The slick side goes up facing the build plate. If you get it wrong, which is easy to do, the print will stick and likely tear. Finally, unlike some other products this one has only one side protected by a blue film. Once you remove the blue protector from one side there’s nothing else to remove.

Excelente calidad

Had a puncture in my factory installed FEP/ACF sheet, these replacements work great. Just a heads up, there is only 1 peelable protective film on each of the 3 replacement sheets, for some reason I thought there was two. The Phrozen tutorial for replacing was great, however they don't have a replacement video for the Mega 8K S, only the Mega 8K, the resin vat hardware between these two units is slightly different so if you have an 8K S just be really aware of what you're doing, I got a little confused on which metal holding piece was which but eventually figured it out.

I had just replaced the factory film with this new film due to minor scratches and wear. I replaced the film after watching a step by step video on how to do so. I have 3 other Anycubic printers that have the same method of replacing the film and understand that there is an "up and down" for these types of films. I have replaced my Anycubic films dozens of times over the course of years and thousands of prints and have never had this issue. About an hour into the first print with the new film stuck to the part I was printing and tore away an entire chunk of the new film. This caused a whole liter of $100 resin to leak all over the floor and through the hole onto the screen. Luckily I had a screen protector on my Mega 8 K S, or this $150 problem would have cost me a whole new printer. The part is stuck so thoroughly to the torn off chunk of film, I couldn't even remove it if I tried. I have just finished wasting about an hour of my time and $150 just to get back to the same point I was yesterday, before I had replaced the film. I do not trust the other 2 films in this cardboard tube and am going to attempt to get a refund issued and hope for some sort of reimbursement for the sheer amount of damages and wasted hours I have spent because of this product. I have no idea what film to buy next. I had assumed that this was the exactly the same quality as the film that came factory installed with the printer, but obviously this is either a knock off or Phrozen has gone very downhill with quality since the Mega 8 K S initially released. If the $5 a piece Anycubic films are any comparison and each of these new films cost over $30, I expect them to last months, not an hour.

ACF bastante bueno para impresion