POWERTEC 70319 Hangers for 2-1/2" Dust Collection Hose and Pipe, 5 PK

This was exactly as described and works perfectly.

I purchased this rubber pipe coupler to support my 2 1/2 inch dust collection system. This coupler’s inner diameter measures a little bit bigger than 2 1/2 inches. As a result, it fits very easily over my 2 1/2 inch exterior diameter pipe and couplers.The pipe clamps that come with the coupler cinch down very easily and buttoned up my dust collection system perfectly. It was just what I needed.I recommend the use of this 2 1/2 inch rubber coupler for your desk collection system as well.

Measurements are a little hard to follow, I actually made a mockup so I could test the measurements before I drilled holes in my project. Well made, works as advertised.

Fits both my Rigid shop vac and the Oneida cyclone dust separator perfectly

As expected.

I like the plastic hangers but to use them on 2-1/2" tubes and the "y" fittings of the dust collectors they are too short to allow fastening with both screws. There is such a stress I was concerned the tubes may crack especially when the clear elbows and "Y" fittings are used yet these are what are sold with the $136 kit. Makes me wonder if anyone has actually laid out the usage during design. If Powertec has a solution I am interested to know if they want to revisit what they are recommending and selling.

Worked as intended to hold on to the back of the miter saw.