48V Adjustable dc Power Supply 600W,Switching Power Supply AC 110V/220V to DC 0-48V DC Converter with LED Digital Display, 5V 24V 36V Buck Converter for Dimmable LEDs,3D Printer,Computer Lab

Works great. Tested it volts, are within a tenth. Works great for all my projects. The load terminal is right under the amps Dial. Makes it a little tricky to tighten.

Voltage reading is close enough that I didnt need to worry about it, but better to check with a multimeter anyway. We needed a power supply to replace the cheaply made power brick that came with our nvr. This was perfect. If there is anything I would change, it would be the knobs. They are a bit touchy and protrude far enough that just grazing it changes the voltage quite a bit. After the warranty is up, l'll probably modify it so I won't worry about cooking the nvr on accident while dusting. The nvr doesn't put much of a load on it, and I haven't tested the ps for anything other than what I need it for. Here's hoping it will last!

This is a well built unit that does it's job very well. I set up one set of leads with gator clips and one with a XT90 connector. It's easy to control the voltage and amperage. My only real issue is a lack of a way to wall mount it. I have this out in my shed and I'd like to mount it to a plywood electronics board (plywood screwed into studs where I mount inverters, bus bars, etc.). Other than that, I have no issues with it. I give it a 4.5 stars

works well for my lighting system, which is low voltage relays operations.

I have had many of this type of pw over the years, many seem to burn out in the first year of constant service. This one has not. Ony small issue is the meter slide out of the housing when bumped once. Few screws opened it up, dab of glue and has been fine ever since. I do run this 25A supply at the recommended 20A or less setting.

Due to the placement of the current control knob it is impossible to accurately loosen and tighten the line attachment wire. You have to remove the top cover,(breaking the inspection seal in the process), in order to get a good fit with the screw driver. I’m considering returning for this reason.

Highly recommend good purchase

Replaced led driver on bar light, like new again.