Renogy Deep Cycle AGM 12 Volt 100Ah Battery, 3% Self-Discharge Rate, 1100A Max Discharge Current, Safe Charge Appliances for RV, Camping, Cabin, Marine and Off-Grid System, Maintenance-Free

Got tired of adding water to both of my 5 year old deep discharge flooded lead acid house batteries for my RV. My battery compartment is just large enough for two Group 31 batteries and these are near in size to that so I bought two of them. It also helps that the price on Amazon is very good! They look good and were easy to install. Quality looks very good, though that's just a visual check at this point in time for me. Note that the terminals have M8 screws - if you get battery cables with M8 (5/16) lugs there will be more metal at the end vs the 3/8 holes on my previous cables which rotted away. Nice removable caps on the battery terminals which help when connecting multiple batteries in parallel. See my photo of the final installation. I bought a Victron SmartShunt IP65 along with the batteries so that I would have more confidence in the state of the batteries when boondocking without shore (120VAC) power. There is a good datasheet for this battery on the Renogy website but that does not include two parameters that can help accuracy with the Victron. So I asked Renogy customer service for the information which they quickly provided! Bravo to them for this! The two parameters and their value are : Peukert’s Constant: 1.1 and Charge Efficiency: 90% I felt that the old batteries didn't have sufficient remaining capacity - though they were originally 120Ah each. Whether that was true or not I really don't know. See below for the reasons for this and why I got the Victron monitor - which I really like. I have a Renogy Rover 30A solar charger which shows the battery voltage and some kind of state of charge (SOC) number. But the voltage on a lead acid battery is an accurate measure of SOC only if the battery has sat completely idle (i.e. disconnected) for at least 24 hours which is a non-starter when you are camping. The solar controller doesn't know how much current is being drawn from my battery pack (both the house load and solar are connected directly to the battery) so it can't calculate any kind of reasonable load drop. From what I read the loaded voltage could be 0.5 to 0.7v or more below the resting voltage as related to SOC. Hence the uncertainty with the old batteries. The shunt battery monitor is in series with the negative battery terminals so it knows all the current in/out of the battery, plus voltages and temperature. So it can calculate SOC more accurately. Note, however, that all it can calculate is the percentage of the battery capacity. If you enter 200Ah as the net capacity for the battery pack and you use 100Ah then it will show roughly 50%. But just exactly what the net remaining capacity is for a battery that is a couple of years old is a difficult question to answer. If the actual capacity has degraded to 150Ah, then that 100Ah discharge is bringing SOC down to 33% which is definitely not good. Apparently the correct way to test actual capacity is to discharge it at the spec rate (100Ah divided by 10 hours equals 10A) until the voltage drops to 10.5V. You want the current to be constant even though the voltage is varying and you definitely want to stop when you get to 10.5V and then immediately charge it up again. I don't see myself setting up such a test fixture nor do I know any place that can do this kind of test...

This battery is just what my camper needed It will run the furnace fan through the night. Holds a charge as advertised and responds to a solar panel charge to reach full capacity easily. It is reasonably heavy, but that's what I have gotten used to in rv batteries. The price is acceptable now.

My got my first battery, it had some charge max problems, not only did the support help me with my charge control they got me a replacement, a year after the first battery i bought from them and it still holds a 87 percent charge, that is with daily 20 percent use. I am glad i returned to this company to start building my solar backup.

These are great batteries but the one thing I’m not happy with is that the terminals are 8mm (metric) and not the industry standard of 3/8”. This makes it a challenge to find a kill switch that can easily be added.

Update: I just completed a14 day dry camping trip (no utilities) where I had to rely on battery power exclusively. I have been doing this for 14 years & use a small Honda generator to charge batteries 3x a day. These batteries outperformed the more expensive batteries I used before. However it is obvious they are meant to be solar backup. They adsorb a charge better, run TV and appliances well but sometimes struggle to start the built-in Onan generator. I also noticed that after sitting in storage for 3 weeks the terminal voltage is 12.8, not the 12.55 - 12.6 of Deep Discharge RV / starting batteries. All-in-all I'm exceptionally pleased. I replaced my 6 yo Duracell AGM's with a pair of these. They claim to deliver 1100 Amps - unrealistically high except for a dead short. After 3 weeks of sitting idle I was pleased that the terminal voltage still was 12.74, a sign of great batteries. Then I started the generator, this pair of batteries barely turned it over, but it started. By the specs, two in parallel should deliver 2200 Amps but barely delivered 110...the max rated starting current for the Onan gen. After the gen started the terminal voltage was only 12.4.

Bought 2 batteries as the reviews were so positive and I wanted at least 100ah for each. Price was right. Batteries arrived ahead of schedule and packaging was in perfect shape. Charged batteries to 100% as recommended before installation. Installed in our RV which has a battery disconnect. Tested the Jack and worked great with full power, turned off disconnect and came back a 6 days later to hook it up and batteries quickly died as I was lifting and then retracting the electric Jack. Battery is to last for up to 3 months when you start with a full charge at temps above 5 degrees. Temperature was above 20 for the 6 days and 45 degrees F when I tried to use tbem. Batteries were at 25% with one measuring 11.7 volts and other 12.1. Put them on a 2amp charger and one battery made it to 95% and the other made it to 35% and that battery started to give a bad battery reading on the digital display on my automatic charger. The battery that charged to 95% had already discharged to 75% the next morning. No wiring was connected to either battery. Although these batteries are non returnable, Amazon is sending me replacements within the next week. I would say do not wait to open and charge these batteries, make sure they test correctly and hold charge. My assumption is that these 2 batteries were stored in an area during transport or at the distribution and we’re allowed to freeze. The fact the both batteries failed would lead me to believe this was the issue. Annoying to install and then need to uninstall along with Amazon not able to physically take the batteries back, now I need to pay to dispose of them. Having said this, I have notoriously bad luck. I hope the next set holds a charge. Amazon customer support is top notch and they always try to make it right.

Pour chalet et alimenté par panneau solaire et très bon prix 🥇

The battery looks very well made, perfect for my application of powering my greenhouse

Couldn't pass up the sale but now will evaluate "longevity" and "value for money"

I did not know if the battery was charged or not when it arrived. The battery failed. I do not know if it was a problem from the battery or from the controller.