Deliver to DESERTCART.COM.KW
IFor best experience Get the App
Instructions: Hot Glue Sticks+ Glue Gun+ Glue Tabs +Golden Dent Lifter 1.Clean damage surface with a clean cloth; 2.Slide one sticks of glue into the glue gun and pre-heat hot glue for 3 mins; 3.Match the glue tabs with the size of dent,largest dents require the large tabs; 4.Hold it in dent with light pressure (about 1-2min); 5.Use the Golden Dent Lifter to pull tabs out(Note: push it slowly and lightly for several times); 6.knock it slightly with a rubber hammer or knockdown,Repeat process until damage is remover; 7.Peel off the glue and clean the surface; Product list: 1 pcs Glue Gun 1 pcs New Bridge Board 24 pcs Glue Tabs 1 pcs T Bar Tool 5 pcs Black Tap Down 1 pcs Mini Bag for Glue Tabs 1 pcs Red Mini T Bar 2 pcs White Glue Sticks( Vscosity is weak ) 2 pcs Yellow Glue Sticks(Vscosity is medium) 2 pcs Bleck Glue Sticks(Viscosity is strong ) 1 pcs Clean Cloth(Length:30 x 30 cm); 2 pcs Plastic shovel 1 pcs Alcohol Bottle (emptoy)
M**K
Thought £50 was worth a shot compared to the garage repair quote. Extremely pleased with the result and learnt a new skill.
First time using a PDR kit. Had a fairly big crease dent with some silly quotes for repair. Heard about PDR so thought I'd give it a try for £50.There's no Isopropyl Alcohol supplied with the kit so had to buy separately.The long hammer pull tool can be broken down so that the short pull bar at the top and the tab grip can be screwed together to form a small Pull bar which was very useful.The glue sticks aren't well labelled so not sure which are more sticky. I ended up pretty much using all the sticks due to the size of the dent.It takes a fair amount of work to pull a large dent.I found the best way of working was to glue multiple tabs on and work your way around the dent.Pulling on multiple tabs gives faster results. Attach the screw puller onto one of the tabs, put tension onto it and then work on the next tab with the hammer pull tool. This doubles up the pull across two glue tabs.Very pleased with the result. Takes time but dent is almost invisible now. As always doing the first 80% is quick but then getting it perfect takes a lot of time with small adjustments.Almost all the tabs are different but I'd have actually preferred a couple of the same so I could glue them in one batch along the crease of the dent but obviously that's a particular requirement to my dent. A couple of larger tabs would also have been good but again what was supplied did work eventually.
A**R
No instructions sent
The kit looks very good, not used yet, but no instructions with it, really bad perhaps you'll send them on to me.
T**E
This is very good for the money
This is very good for the money. Works well and has pulled out the dent I wanted it to. Saved me lot of money.
K**S
I had a dent in a curved roof bar it ...
I had a dent in a curved roof bar it took a couple of attempts but it did the job.
R**D
Five Stars
perfect
ترست بايلوت
منذ 4 أيام
منذ 3 أيام