Cable MattersInternal Mini-SAS SFF-8087 to 4 x SATA Forward Breakout Cable - 0.5m

Just what I was looking for to hook up the internal SATA buses in my home server.

SilverStone の PCケース、SST-CS01-HS のバックプレーンにPCI-SASカードから本ケーブルで接続。 OSから確認してもSATAの6Gbpsでは無くSASの12Gbpsで認識してRAID使用が出来ました。 良い感じです。

These cables work perfectly with 10GTek adapter, and were a breaze to route through my Antec 1200. The extra length is quite nice, and they feel of decent quality.

Board: asus tuf gaming x670e-plus wifi Cpu: ryzen 9 7900x

I've bought these kind of cables of different brands over the years, from cheap temporarily working cables to "premium" brands cables and I've seen differences in quality. Cable Matters are very different, better imo, the way they fit, grip and sit tight on the SATA connector and is truly great, feels solid! No slack/loosely which otherwise could cause momentary disconnection of the drives and causing errors. -This is a early review since I've just bought them, but the first impression gives confidence. I truly recommend anyone looking for new cables to try these.

I needed this SFF 8087 to SATA Forward Breakout Cable, 3.3 feet, which connects the one SFF 8087 Connector on my LSI MegaRAID 9260-8i RAID SBA Card to 4 SATA HDD's. Cables of this type, where you have the one SFF 8087 connector to 4 SATA or SAS HDD's are delicate cables to begin with due to the wire connections, this cable appears well made. The Connectors seem to be of good quality and fit snugly into their receptors, the main leads from the SFF connector are wrapped in a heavy insulator to protect the cables and while I didn't measure the length of this heavy insulator was about halfway on the total cable. The 4 separate leads were smaller wire gauge with a light blue plastic insulator and SATA standard connectors. Each of the 4 connectors were labeled with a simple plastic tag numbered from 1 thru 4 so you can identify each drive connected. I had no problems with communication between the Card and the HDD's, worked perfectly upon installation. The SATA connectors are typical ones that you find on many cables, nothing special, not too hard to install or remove, just press the small spring metal tab and the cable can be removed. They click into place with little effort. In hindsight, I may have tried to find cables with right angle SATA connectors as there wasn't much space between the connector and my case, but it worked without having to bend any wires. Its important that the wires are not crimped when installed. The Cable itself was quite long. I have mine in a large Mid Tower PC Case where the stacked and connected HDD's are to the right of the Motherboard so there was plenty of cable to route around the case. This cable would have been adequate for a larger case as well, either a Server Case or larger tower pc case. The 1.6 foot cable may have also worked but when I ordered it, I didn't want to take any chances on it being too short. Better to run the cable around the perimeter of the case than have it be too short or have to run it too close to a heat source of block airflow. I have other Cable Matters cables and they were of similar good quality, I don't think you can go wrong with this cable.