Key Fob Case Replacement 5 Button for Chevy Cruze Camaro Impala Equinox GMC Terrain Buick Regal Lacrosse 2010 2011 2012 2013 2014 2015 2016 2017 Keyless Entry Remote Control Car Key Fob Shell - 2 Pack

Muy buenos materiales por el precio

These worked great for me! I had 2 fobs. One in ok shape and the other in pieces after a previous owner tried to change the battery I suspect. So I started with the one in pieces. Watch the video to get a basic idea of assembly. I used the key, spring, & button from the original fob. First place the silver battery terminal in place on the edge of the battery compartment. It sits behind two small tabs. Place the circuit board with the buttons into the button half of the case. It should fall into place with an alignment tab into a slot on the circuit board. Set it aside. Take your key, spring, & button. Make sure the button is properly aligned with the slots in the key. When it protrudes the most it is right, otherwise it’ll barely stick out. Now the fun part. Place the key,button, spring assembly onto the back half of the fob, wind it once counter clockwise, and press the key down into the closed position. If it doesn’t lay flat your button isn’t aligned properly. Then holding that in place take the other half of the case, align them together, and carefully snap them together. It may take a few tries or extra hand. Now try the key button. If the key doesn’t flip open easily, try two turns on the spring. Install a new battery and the cover should easily snap into place. Now try the remote! Getting into the other remote wasn’t easy. I used a flat tip screwdriver in the slots at the top of the remote where the key attaches. I twisted the tip to break the glued halves apart at the top and just enough on the two sides to get them pried just far enough for the circuit board to slip out. DON’T get in a hurry and damage the board. These do work and are a great bargain at this price. The buttons are a bit stiff due to being a flexible plastic instead of rubber but not bad at all in my opinion.

Make sure you pay attention to what part goes where. Great product, easy to assemble and reassemble. I didn’t even need to program the key, that’s how excellent it works. Much better than paying a dealer for a new fob!

Great product come with excellent tools and accessories. I love it

Great product, seems sturdy, time will tell. As others have noted my factory key didn’t fit into the opening on this fob. I had some 80 grit sand paper handy and the edge of a table, 1-2 minutes later it fit perfect (a little of the top, a little off the top of the sides). I did have to pound the pin out with a micro screwdriver (glasses screw driver).