InoKraft MaXpray M1 Airless Paint Sprayer, 207 Bar Max Pressure, Covers up to 7 m²/min, 466W Thinning-Free Paint Sprayer for Walls and Ceilings, Wood & Metal, 7.6m Hose, Extension Pole & Accessories

It works. It's the first time I ever used one of these but it's the dogs ballerics. It normally takes me 5 days two people to do a colour change on a 4 bed house every room without the ceilings. It took me 8 hours the first time I used it including the cielings, all white.. It took an hour to paint a breeze block room and ceiling which normally takes about 8 hours. Would I buy it again. Yes. Watch the you tube videos, it so easy to use and set up. I did a living room and kitchen last week, walls magnolia and ceiling white in an hour, plus 45 minutes masking. You quickly learn how to get super close by turning the power up or down. And changing paint from white to magnolia, i just swapped the suction hose from white to magnolia and ran the white out into a bucked rather than clean it. It worked perfectly. Spray quality is 100% better than a brush or roller, covers stains and marks 100 times quicker, mine does not leak, made its money back on my first job so definitelyvalue for money. Functionality i got my ten year old to set it up because of course he waanted a go. Make sure you have a decent mask, you will need one.

Almost as good as the best. Took a chance on this because of the good reviews and it was at least a hundred cheaper than the equivalent Wagner. My friend is a painter so showed me how to use it but after looking at the clear laminated instructions I could have figured out it easily enough. The technique is easy enough, watch a few utube videos before. He said it performed just as well as his pro machine just had a different hose, not as long or flexible maybe but nothing for me to worry about. Anyway with this machine I was able to spray the ceilings of my entire 3 floor house in a few hours and skirts too. I cannot emphasize enough how much neck ache would have ensued if I'd spent days doing this with a roller and brush! If I never use it again it was still money well spent. The finish is perfectly professional though technique and choice of paint plays a big part in this... Do your research!!! Setup and cleaning after is as easy as it gets if you're using water based paint. The extension tool is a great addition, if I was spraying all the time I'd get all the other necessary tips but I just borrowed one for the skirts. Overall I'd say if you have a big job to do like I did then this machine ticks all the boxes and I fully recommend, if you can go halves with a friend or relative who wants to do their house even better.

Stopped working on 3rd use. First 2 times worked amazingly, cleaned it thoroughly and boxed it back up, stored in a dry space in the loft. After about 5 months of not using it I went to use it again and it just didn't work. I emailed support who never responded. I followed youtube support videos but it never came back to life. A shame because the first jobs it did were incredible. I'm not a mechanic but all i can think is the motor seized through lack of use, but for a product not even used 3 times this isn't good.

It works well but uses more paint and once you start to reach the last 8cm in the bottom of your paint tin it stops you have to refill and on larger jobs means you are having to prime it before you can continue. But on the whole great bit of kit making the hard work easy.

This is a great quality machine. I’m a keen DIY’er had sprayed garden fences with the Wagner kit which was ok for the job. I had some ceilings replaced and wanted a decent finish so opted to buy the is sprayer. It worked a treat to get two coats on, but my low skill level meant they were a wee bit patchy and I did the 3rd with a roller. I was trying to manoeuvre around kitchen units etc which made it a bit difficult to get straight on, having to tilt at an angle meant I had some lines. I got better as I went so with proactive In sure I could do a very good job, without the lines. I’d recommend if you do a lot of painting. I was using Matt emulsion, it was no problem whatsoever. Easy to clean following the instructions. One point to watch out for. I ended up covered in paint when the hose disconnected, so make sure you fully tighten the nuts and check periodically as you work.

Amazing piece of equipment !! So easy to set up and use it's unreal I half expected a mad contraption with 100's of parts and processes but putting together was simple and using the machine even easier. Before using when you do the first flush of the system you might have to use the hose pipe cleaning method to activate the internal parts properly but after that I cleaned using the bucket (pale) of water method and it cleaned with ease. It covers a massive area in no time at all and the final finish is flawless, when it came to cleaning it was so easy to take apart and clean I would 100% recommend this product to anyone beginner or professional.

The MaXpray M1 is a game-changer for my DIY projects. It’s far quicker than rollers or brushes, and the finish looks professionally done. I’ve used it on walls, furniture, and my garden fence, and it handled each job smoothly without clogging or fuss. Setup was simple thanks to the clear instructions and YouTube tutorials, and the 360° swivel joint made it easy to reach tricky angles. Cleaning is impressively quick – about 10 minutes with the Flush-Ease Valve – and the spray tip delivers an even coat without needing to thin the paint. I also noticed much less overspray, which saved me money on paint. The included accessories are thoughtful too: the tip extension saved my back when painting high spots, and the anti-fog goggles are great for safety. The motor feels strong and reliable, and customer service has been fantastic – responsive, friendly, and helpful. With the option to extend the warranty, I feel confident this sprayer will last me a long time.