Front & Rear Engine Mount Kit Motor Mount | Compatible with 2011-2019 Dodge Durango 3.6L 5.7L, 2011-2019 Jeep Grand Cherokee 3.6L 5.7L 6.4L Engine Mount Kit

They all felt solid in construction and fit great as replacements. Replacement and installation wasn't necessarily easy, but that's because you're replacing motor mounts... not a fault of the product. I knew I needed at least one, and so I decided I would do them all. Glad I did as 2 of them were completely shot and falling apart. Side by side these parts looked almost identical to the original and were completely compatible. Photo and video show just how shot 2 of my old ones were compared to the new. Glad I took care of these before things got worse.

awesome product for my kid's car. Installation was a snap, perfect fit.

Fit great in the 06 torrent with the 3.4 i think. AWD. Seemed pretty decent. I dont recall which but one of em fought me considerably. I think it was the front one closest the bumper. The old one came out quite easy so i grabbed that and realized it came out easy because it was that worn out. I fooled with it a bit, jacking here, pushing there, and it finally went in. I got this set for less than the cost of the single one i actually needed at the part store. Had em in there a while and still doing what they were hired to do and i dont drive this thing easy. It used to be the flagship of the fleet but it left the wife stranded a while back and has since hit me with some of the most interesting and unique issues. The wife has since taken my truck, i assuming so she can not wax that either, and left me with this science fair project for when it rains and my jeep when it doesent. Ill keep her going until it gets too costly or it blows up but otherwise, good mounts. Id buy again.

Installed these on my 2010 Mazda 3 2.5l. Perfect fit and it helped with the vibration I was having. They are very easy to install and if you're handy and have common sense, this is a doable maintenance task.

The right engine mount is different on an e46 330xi. This model uses an angled hydraulic mount. The transmission mount is different on an e46 330xi. This model uses transfer case bushings instead. Was able to use one of the engine mounts only from this kit.

Arrived very fast and the fit was perfect. Thanks

Bolted right up no problems on my 06 impala 3.5

Absolute trash, the front motor mount has two holes with nuts welded (I use the term welded VERY loosely as I've seen better quality welds come from a trade school for the blind) and one of them was welded at an angle that even not installed you couldn't get a bolt through which is the less important of the two defects on this one mount. The other being the bushing is so far off both low and toward the rear of my Jeep that it's impossible to get the through bolt installed unless I put so much force on it that it's going to rip the rubber off the bushing. I should have knowing that nothing at this price point could be of any quality or use. When I say the welds are bad I truly mean they look like they invited random people of the street at 3am during Mardi gras and anyone that said they had no experience and had never attempted to weld were the only ones allowed to try. So now I'm pulling them off and they are going right back to China and they can put them on a rickshaw as shock absorbers or something. Absolute garbage, they don't even have the same amount of rubber in the bushings (when compared side by side) as the set from Amazon I'm removing that were installed 3 years ago. The metal boarding the bushing is also much thinner and the hole fit the through bolt had a larger diameter (probably because the bigger the hole the less rubber they need for the bushing, who cares that it allows you engine or transmission to travel further before slamming into resistance, it's only the customers vehicles!!! Stay away from ANYTHING this company has to offer, except for your refund!

Excelente calidad , superó expectativas ya tengo más de un año de uso y todo bien