BOSCH00620774 Dishwasher Drain Pump

Perfect match perfect fit. Plug and play from the front of the machine. In and out in 5 minutes and it’s working perfectly

OEM product. Great price. Our dishwasher threw an E-24 code, drainage problem. It would not drain the tub. On line comments lead me to believe the fault was the drainage pump. The filter was perfectly clean. After replacing the pump which was very quick and easy we found the air gap assembly was clogged. Easy to remove the offending detergent blockage by tapping on the plastic part (heated by the washer) located on the left side of the washer after pulling it out from under the counter. Blockage at the top of this 6 by 10 inch assembly.Note: This is a current production unit as of 2-2019. The older units reviewed on the net are the older models that use an air gap located remotely at the sink area. Our local dealer said this is a common problem prevented by using the properdetergent. No regrets.

This does NOT fit Bosch model SHX68T55UC/07. It fits in place, the clips match but the dishwasher would not run. Had to re-install the old pump. Visually it doesn't match with the correct part either

My Bosch Dishwasher shut off, leaving standing water in the bottom of the machine and displayed an "E25" Error Code. The recommendation on the Bosch website was to call an authorized Bosch service technician to address the problem. Because my unit is outside the manufacturer's warranty period, the cost would be as follows: $159 Call Out Fee plus charges for labor ($20 for every 6 minutes) and any parts used. After searching the internet and reviewing several Youtube videos on replacing the pump, I decided to order the part from Amazon and perform the labor myself. Well worth the minimal effort and skill required!!

it works but part seem to be used

Easy to change.

This drain pump works perfectly with my Bosch dishwasher. I had code E25, which means that the drain pump was having problems. The part came in a nicely wrapped in bubble wrap inside a packaged cardboard box. Removal of the older unit is a little tricky because you must rotate it counter clockwise from the top of the pump. Remember to remove the cable unit from the old unit before removal. It also takes a little strength to get the old unit to turn clockwise.Once the old unit is removed, the new unit fits perfectly. I had to adjust my dishwasher front height to allow the proper insertion of the new unit back into the dishwasher. Once seated, push the pump into the housing and rotate counter clockwise. Re-connect the power cable housing. Voila!BTW- my old unit had hair wrapped around the base of the rotating impeller. Even after removal, the impeller was stiff to rotate. The new unit is light and easy to rotate.

First one lasted 6 weeks. Pulled pump and rusty water was dumping out of pump. The second one just went in. When I pulled from the box, it was a bit dirty. It was hard to tell if it was just the box flaking onto the pump. The color of the dirt / dust matched the box and it look like small shreds of cardboard. If this second continues to work then I will update this review. But until then, proceed with caution. The seller is "The Bosch Store" which implies direct from Bosch, but if you look at the seller it says "Parts Supply Warehouse". I recommend finding a local store with genuine, new Bosch parts.