When setting the gain on my amp, do I set bass knob remote included all the way up or all the way down? (Not talking about the bass boost on the amp)

Step 2: Flatten the signal, open the low-pass filter. Turn your sub amp's gain to its lowest, most counter-clockwise position. ...Step 3: Adjust the subwoofer gain and low-pass filter. Play music through your receiver at about one-quarter volume. ...Step 4: Bass boost and subsonic filter.

Will this power 4 Kenwood 5 way 6x9 speakers

This is mono Amp which is 1 channel to power only the sub woofer. You need a stereo amp which is muti channel to power your speakers usually you need the same number of channels on your amp as many speakers you need to power so that you can control the speakers individually and give them power they need without sharing. Stereo amps can power woofers too but it has to be bridged some do have seperate channels to power subwoofers too. Its recommended to follow and match rms value for speakers and amplifier. A bit higher or lower than rms value will be good to go but for best performamce you should be close to required rms value and ignore the peak value for both.

Specification Met	Cea-2006
Number of Channels	1
Package Type	Standard_packaging
Mounting Type	Car Mount
Voltage	14.4 Volts, 16 Volts
Material Type	Aluminum, Steel, Plastic
Item Dimensions	15.3 x 4.8 x 10.2 inches

Kenwood KAC-9106D 2000W Monoblock Class D Car Audio Power Amplifier

التفاصيل

الوصف

المواصفات

لديك سؤال؟ انظر ماذا طلب الآخرون

الأسئلة الشائعة