CoiTek Foam Cutter,Styrofoam Cutting Tool Kit,10CM Hot Cutting Pen with Transformer Adaptor

Works well, don't try to force it, and wipe blade with damp cloth frequently.

Excellent tool, massive improvement compared to using hand saws, quick and no mess.

I used this to carve 3cm thick polyurethane foam for a tool box insert. It leaves a few scorch marks, as expected, but it's easy to handle and did the job. A cardboard template made the job straightforward and some sort of guide is a necessity for a decent result. You need to take time to practice and go slowly; I used a damp kitchen towel to occasionally wipe the cutting part. It gets hot so take care not to burn yourself or any surrounding material.

Works ok, heats up quickly and I'm only cutting 12mm deep foam but does struggle a bit and that might be because the form is quite dense. Anyway acceptable cuts by taking things slow and thus 3 stars.

Pleasently surprised wasn't really expecting too much TBH. That said though it worked well. Patience is the key word here, take your time and it cuts really well, once you've got that sorted it's really easy to use. So for the price you pay it's good value for money. It looks flimsy just outa the box but does the job. Just remember to clean the "blade" regularly as there is a build up quickly and as you'd imagine can smell a bit cutting through.

ive seen alot of people say on here on the rod snapped now ive not had an issue with mine personally i was able to cut though 50mm of grey styrofoam defoo keep doors or windows open and wear a mask because cutting such materials smells pretty bad & i reason this isnt 5 stars because i think rod could be longer or thicker

This device is no more than. a soldering rod with less heat than a soldering iron. It burns through the foam, but cools down quickly. It doesn't produce a clean cut because it hasn't got a blade, hence why it should not be advertised as a "cutter". Very poor result. Not sure what people would buy this for. I think I would have been better off using sharp scissors and spending money on a scissor sharpener.

Bought to cut shapes in polystyrene and it heats up fast and cuts fine but you have to have a steady hand as it will cut very quickly. Needs a wipe every so often to take of melted polystyrene. It is by its nature and requirement a thin piece of metal so could be damaged relatively easily but so far it has worked fine and been fit for purpose. It did its job!

Nul. Ne chauffe pas assez donc coupe rien. L'aiguille de chauffe est tellement fine qu'au bout de 5 minutes d'utilisation celle-ci était déjà tordue et inutilisable. Produit à fuir.