Nooelec Lana - Ultra Low-Noise Amplifier (LNA) Module for RF & Software Defined Radio (SDR) with Enclosure & Accessories. Wideband 20MHz-4000MHz Frequency Capability with Bias Tee & USB Power Options

Like other Nooelec products that I have purchased, this LANA amplifier is well made and works as stated. You do have to filter out any other interference, like 14.5kW Radio Amor 100.3 FM, or you will end up amplifying interference as well as your signal. However, using the Nooelec broadcast FM filter, I am able to get many more signals in the 1-2GHz range. I use this amp with an SDR Play 1A and I use its bias-T to power the amp. Powering it this way, I do not need to put a DC block in line with the receiver. If you power the amp through the micro USB, you should get the Nooelec DC block or another brands DC block. The amplification range is from 20MHz to 4GHz, so it does nothing for HF signals. I found the amp to be low noise and have low insertion loss. The 85mA low power consumption makes it ideal for the SDR Play. Some reviews said that the amp does not work, but keep in mind that the LED power light should be facing your receiver or you will only see noise and think the LANA does work. This is a well made, general purpose RF amp. I like Nooelec and their well made, high value products with cool names. Get one, it's fun to play with.

I purchased this to use with a scanner with an attic mounted antenna and long feeder run. The low Noise Figure and decent gain of the LNA made a big difference to reception, for example I'm now able to pickup the control tower at a local airport where previously I could only receive aircraft that were airborne. The device is very well made with an extruded case housing a very nice PCB with the RF electronics inside another screened enclosure. There are options to power feed the device using DC via the coax on the Output connector using an external Bias-Tee or it can be powered via USB connector from a local PSU. But be aware then when you use the USB connector the DC voltage is fed back down the coax which could potentially damage a connected receiver, so when using with a local PSU via USB a coaxial DC block should be used on the Output side. This isn't a product deficiency and it's clear from the spec sheet that it works this way, but it is something to be aware of - I only realized it because the power LED went out when I connected the feeder down the scanner.

Works great. Indispensable product in every amateur SDR kit

Unit seemed to work well. However, the status/ON light seemed to have stopped working after a few weeks. Seemed to still work though. Returned it for that reason.

Made noise level jump and signal levels drop to nothing right out of the box. I had to return it. Looking like 11 % so far negative reviews so maybe a quality control issue?

Yeah you definitely need this for your rig, it helps draw in all those signals that would just be out of each otherwise, I operate out of my tundra in this helps blow past the EMF shielding my cab creates to pull in drone signals from miles away. 5 out of five would purchase again

Works fine and a reasonably inexpensive route into H1 radio astronomy. This is my second purchase which I use for live public demonstrations of galactic arm movement.

Excelente