RGBWW LED Strip Lights 16.4ft 300LEDs DC 12V SMD 5050 Waterproof RGB With Warm White LED Tape Light LED Ribbon Lights Home Decoration Lighting Flexible Lamp Band (Not include power and controller)

Lights were perfect for the project I was working on.

Seems to work well, so far, but the LEDs alternate between RGB and W, rather than all of them being RGBW. I see it in the images now, so can't really fault the seller. Knocked 1 star off because the backing tape on the adhesive is awful, which is going to prove annoying.

I ordered two of these. Both arrived broken. One clearly is used, as the sticky backing is coming away and the connector was entirely separate from the LED strip. The other simply didn't work when I tried it. So I delved in a little more and found that the black wire (the common one used for positive supply) wasn't actually connected to the LED strip - something you can only see when removing the protective heat shrink wrap from the end.All together very poor quality. Added to this is the non-standard order of the colours. Rather than the normal RGBW this is actually GRBW. This means you get the wrong colours unless you manually change the order of the wires.

This is a 10 mm 5 pin LED light, which as far as I can see, is just as good as others on here. The problem I had was finding 10mm 5 pin accessories, there are lots of 4 pin 10mm or 12mm 5 pin, but a limited amount of 5 pin 10mm. And what you can get is usually more expensive. (Plus Amazon's suggestion of what others brought when they bought this, is the wrong size for this light!!) The sticky back is quite good, I had to take my strip on and off quite a few times and it still remains stuck. Although on one roll, the sticky back had been manufactured incorrectly and was missing.You have to be careful when cutting the LED, the clear rubber case is difficult to cut and you can go too far and cut the LED. Because of the lack of accessories, I ended up soldering wires on to turn corners etc... and this was a nightmare to do.

Within a month and hardly any use the colour changed on some LEDs. The worst part - they were stuck down with the adhesive tape and I had to remove them to send them back for refund - and this caused damage that meant I had to have the wall repainted!

Pretty much as described. Did not come with any power supply or remote - wasn't in description either so didn't expect it.One end pre-wired well BUT given three star for "easy to install" as the red and green wiring is connected wrong way round, so when connected to RGBW controller the red comes on instead of green and vice versa. Not a major issue as just meant putting red wire into green power output to get green LEDs to light.Haven't used adhesive tape yet as installing on bare wood so expect adhesion wouldn't be too great - just using a standard stapler to hold in place.

I installed these strips with an LED Driver that allows remote control and for a few weeks all was great but recently the white LEDs have started to randomly drop out. I now have around 10% loss of the white LEDs but all of the RGB LEDs are still working fine.3 months after installing these, I now have a significant number of the white LEDs not working. The RGB still seem to work ok but I am very disappointed about the loss of the white LEDs and even more disappointed that the vendor/manufacturer have not been in touch - are they not bothered about customer satisfaction, quality of product or feedback for continuous improvement?After 6 months, I have gradually been losing more of the white LEDs and quite a few RGB - mainly Red and blue but green seem more reliable however they now don’t do what they are supposed to due to the losses - very disappointed and have reduced my review to 1 star as cannot do zero stars!

The worse led strip lights