6 Way Fuse Block

This is a very good fuse block. It is very compact and can deliver up to 20A per circuit, and can handle up to 75A for the whole block. It can be used on 12V and 24V volt systems. That is impressive for such a compact design. It has 6 circuits for lots of accessories. The fuse block is easy to place and install. Wiring is a breeze and it performs very reliably. It comes with fuses, protective cover and identification stickers for each circuit. This fuse block is well designed, top quality and is a great value for the money. I give it 5 stars.

After reading several reviews of several different fuse blocks with grounds with problems like lugs stripping and ground bus bars being to close to the positive I rolled the dice and bought this one to use behind the helm of a boat. Comparable to Blue Sea 6 fuse block at $67 this is a great value at $17. It's very solid and has a quality feel to it. I opened it up and the lugs are held into place with double nuts so it will not strip. The negative bus in the right of the picture looks like it's a milometer from the positive, but the negative is actually recessed below the positive so no chance of a short. Fuses hold nicely but are easy enough to remove. Also checked and all metal components are stainless steel, so it is marine ready. Now the bad as others have pointed out. Absolutely not even close to waterproof. Cover is ridiculously oversized and sits way to high. Overall a lot of bang for the buck on this solid fuse block.

This panel is a great fit. I have it installed in my F150 right next to the OE fuse panel in the cab (passenger kick panel). You wouldn't know it's there if not for the 30A breaker I have in the engine compartment on the 10ga wire feeding this from the battery. The terminals are all a great fit and I had no issues getting standard ring and spade terminals to work with this panel. While this is great in a vehicle interior, this panel is not waterproof. I wouldn't recommend using it in the engine bay. The cover is enough to protect it from wet/snowy feet getting in and out though. The built-in ground bus provides me a nice auxiliary panel for aftermarket equipment on my vehicle. This is much better than using in-line fuse holders and grounding to chassis. I have this panel providing power to my dash camera, LTE router, and an ethernet switch. To save my vehicle battery I have also wired in a Havis Charge Guard (sold separately) to kill power completely once everything has shut down on its own or if the battery voltage drops too low.

This is a pretty simple unit. Connect power on one side and ground the other and you are good to go. The issue for me is the lid. It sticks up about 3 time higher than it needs to be and may cause fitment issues on certain applications. There is no reason for it to be this tall and it could be a lot slimmer. Works great otherwise.

Used this to add a lot of extra functionality to my camper docking station without having to run circuits back to the fuse panel on the other end of the camper. You can't see it here, but it's connected directly to the battery shutoff and mounted on the floor under the water inlet. All of the switches and outlets are connected to it, and while I can't testify as to its weather resistance yet, I am happy it advertises that feature since it is mounted so close to the water.

I haven't actually hooked it up yet but I can tell it's exactly what I needed

Good auxiliary fuse block

This was used on a rebuild of a 1959 snowcat, and does fit nicely inside the dash. The terminals are confusing though. Both terminals were unsupported on the bottom, meaning that they are easily susceptible to twisting damage. In addition, one side is connected to a common hot. The other terminal is non-fused, but also not a common hot. Not sure that that one is for. And, it really works best with the forked connectors instead of the round ones, because the screws do not come out well. It works, and since it fit where I wanted it, I used it. It's simply not great quality, and I have no idea how long it will last.

Quality goods

For RV power connections

il y a de la place pour toutes les bornes positives et négatives, les fusible sont un peu difficile a insérer mais ne nuit aucunement a aucune fonction. les collants inficatifs sont un peu trop grands pour les trous prévu a cet effet dans le couvercle transparent. Tout est bien construit, fiable, solide, je recommende ce produit pour tout vos projets :) l'ajout de fusible pour tous vos circuits électrique est essentiel afin d'éviter des incendies ou de longues heures de trubbleshooting.

Quality is good so is price.

Arrived on time and product as per description. It worked out great for my project, I recommend.